- Tab Content
-
Older Activity
-
03-20-2024, 08:06 AMI am using a dry teflon lube on the aluminum rails since the plastic pieces between the metal are gone and there is metal on metal contact. Limited...7 replies | 396 view(s)
-
03-19-2024, 08:29 AMThat space may be for ventilation...probably should not fill it with stuff.4 replies | 460 view(s)
-
03-15-2024, 08:15 AMSometimes they fail and will not roll up or down and need replacement...6 replies | 669 view(s)
-
03-14-2024, 08:07 AMJust make sure the rims can handle the higher rated tires...35 replies | 3137 view(s)
-
03-10-2024, 09:33 AMThat is what I did...2" is the max I read.12 replies | 1624 view(s)
-
03-07-2024, 07:53 AMGrandesigner replied to a thread Towing level with the newer trucks in Towing, Hitching & ManeuveringYou won't really know for sure until it is all loaded and hooked up to the truck, sadly...9 replies | 1784 view(s)
-
02-24-2024, 08:39 AMSo they were lag screws?10 replies | 1558 view(s)
-
02-21-2024, 07:59 AMGrandesigner replied to a thread Would you buy again. in New To RV'ing, Purchase Questions & General ConcernsThe other disadvantage is finding a replacement, with that weird bolt pattern... Not had problems otherwise.63 replies | 5987 view(s)
-
02-17-2024, 08:52 AMGrandesigner replied to a thread Would you buy again. in New To RV'ing, Purchase Questions & General ConcernsIf I had known the slide out 'rack' was marginal I guess we would not have an appointment to replace it with a better quality one this year. A $5k...63 replies | 5987 view(s)
-
02-17-2024, 08:49 AMSurface prep is the key to those sticking on. Had some stick on deflectors on my old truck for 2 decades with no issues... As to how much they would...4 replies | 354 view(s)
-
02-15-2024, 11:18 AMBTDT, no issues so far after a year and thousands of miles...12 replies | 2493 view(s)
-
02-14-2024, 08:05 AMGrandesigner replied to a thread How to get a wet bolt to take grease in Axles, Brakes, and SuspensionYup, I had to replace one that did spin and had to install it from the other side to get it to spline in correctly...34 replies | 4590 view(s)
-
02-13-2024, 08:09 AMGrandesigner replied to a thread How to get a wet bolt to take grease in Axles, Brakes, and SuspensionI will have to try #3 this year as I have one very stubborn bolt that won't take grease...thanks!34 replies | 4590 view(s)
-
02-12-2024, 07:56 AMI would try to get the easiest one out and look at it. Could be lag screw? If it just keeps turning, then yeah, may be bolts...10 replies | 1558 view(s)
-
02-05-2024, 08:08 AMPSA...too common for folks with a 3/4 ton truck and a diesel engine. Not much payload left to justify the diesel engine...5 replies | 673 view(s)
-
02-04-2024, 08:38 AMGrandesigner replied to a thread Has anyone experienced a burning smell from heat vents? in Heating and Air Conditioning systems.Yes, we notice a burning smell like dust maybe? Especially when the furnace has NOT been running for a while, but not all the time. Free bump for...7 replies | 1365 view(s)
About Grandesigner
Basic Information
About Grandesigner
- Location:
- Central NM, USA!
- Product Line:
- Momentum
Signature
Dan and Rita
2021 Reflection150 260RD, built June 2020, w/400W solar + 2 size 31 AGMs, added 2" lift blocks to match the
2022 F350 SCSB 7.3 GdZa 4x4, 10 Sp w/4.30s - Lariat Sport in Atlas Blue
2021 Reflection150 260RD, built June 2020, w/400W solar + 2 size 31 AGMs, added 2" lift blocks to match the
2022 F350 SCSB 7.3 GdZa 4x4, 10 Sp w/4.30s - Lariat Sport in Atlas Blue
Statistics
Total Posts
- Total Posts
- 1,044
- Posts Per Day
- 0.76
General Information
- Last Activity
- 03-24-2024 07:47 PM
- Join Date
- 07-02-2020
- Referrals
- 0
03-19-2024
- 09:29 PM - bricknhank clicked Likes for this post: Towing level with the newer trucks by GrandesignerYou won't really know...
08-06-2023
- 04:43 PM - Mark_270BN mentioned Grandesigner in post Towing a 150 series trailerGrandesigner I hooked up the 270...
07-26-2023
- 11:34 AM - Soundsailor mentioned Grandesigner in post Turn off rain sensor on Maxxair fan (4951KS)?Thanks, Grandesigner, do you know where t...
03-17-2023
- 09:53 AM - Castlerock mentioned Grandesigner in post Turning Point and Curt CrosswingGrandesigner Just curious what h...
02-13-2023
- 08:38 AM - Soundsailor mentioned Grandesigner in post Sumo spring (Momentum 320G)...post a picture, as Grandesigner said, there was no s...
11-01-2022
- 08:47 AM - Castlerock mentioned Grandesigner in post New Truck Too Tall to TowGrandesigner My payload is liste...
- 07:38 AM - Grandesigner mentioned Castlerock in post New Truck Too Tall to Tow... higher than mine. Castlerock What does your door ...
10-18-2022
- 06:37 PM - Castlerock mentioned Grandesigner in post New Truck Too Tall to TowGrandesigner Measurements for ...
- 05:48 PM - Deleted Posts
- 01:28 PM - Castlerock mentioned Grandesigner in post New Truck Too Tall to TowGrandesigner I'm going to measur...
- 12:56 PM - Castlerock mentioned Grandesigner in post New Truck Too Tall to TowGrandesigner I have the same t...
08-22-2022
- 09:02 AM - Skidlm mentioned Grandesigner in post Pin box optionsGrandesigner, pls scroll up to re...
08-24-2021
- 08:09 PM - traveldawg mentioned Grandesigner in post Glacier NP...Medicine tomorrow. Grandesigner I hope you don't ch...
03-24-2021
- 05:02 PM - AmeliaKD mentioned Grandesigner in post Looking at a '21 260RD this weekend...etup is the same as Grandesigner. My hubby has a pic...
10-27-2020
- 09:12 AM - Gran Casita mentioned Grandesigner in post Sumo Springs/Shock Absorbers...d to have...is it? Grandesigner, Absolutely easier t...
09-23-2020
- 08:21 AM - boyscout mentioned Grandesigner in post Power roof vent issue...ked in post #13 to Grandesigner above?
07-09-2020
- 03:35 PM - Grandesigner mentioned eleosky in post Curt 16keleosky Same hitch, no prob...
08-12-2022
- 08:26 PM - powerscol quoted Grandesigner in post Alaska Bound end of JulyJust curious, because we prefer b...
08-11-2022
- 02:52 PM - Riverbug quoted Grandesigner in post To Drain Hot Water tank or not ...Strange, but I find removing the ...
08-10-2022
- 08:41 AM - 4x4dually quoted Grandesigner in post Indoor vs. Outdoor Speaker VolumeUnless your head unit has a fader...
08-07-2022
- 12:04 AM - powerscol quoted Grandesigner in post Alaska Bound end of JulyDo you do laundry a lot or is thi...
08-03-2022
- 09:12 PM - powerscol quoted Grandesigner in post Alaska Bound end of JulyDo you do laundry a lot or is thi...
08-01-2022
- 05:21 PM - Grandesigner quoted MN_Rider in post Norcold Refrigerator Water IssueThanks for the posts on this ...
06-30-2022
- 10:14 AM - Fsalmy quoted Grandesigner in post Roadside Assistance ProgramsI guess I'm asking which ones wil...
06-29-2022
- 06:34 PM - Second Chance quoted Grandesigner in post Roadside Assistance ProgramsI know, kind of old thread...came...
06-19-2022
- 09:42 AM - Grandesigner quoted powerscol in post 260RD battery drain issueDan It depends how the solar i...
- 09:41 AM - powerscol quoted Grandesigner in post 260RD battery drain issueBut if solar is working and there...
- 09:07 AM - Grandesigner quoted cpe111 in post 260RD battery drain issueThere are other things that...
06-18-2022
- 04:09 PM - Soundsailor quoted Grandesigner in post 260RD window replacement!I would have ordered them but it ...
06-05-2022
- 12:03 PM - Grandesigner quoted Redapple63 in post Wet bolt install questionThanks for the update. Which lo...
- 11:48 AM - Redapple63 quoted Grandesigner in post Wet bolt install questionUpdate With the lock n lube I now...
06-04-2022
- 08:55 AM - Deleted Posts
- 08:54 AM - Grandesigner quoted DalePatterson in post 30 Vs 50 AmpI know this has been discussed, bu...
05-31-2022
- 07:34 PM - jkwilson quoted Grandesigner in post Brake Magnet Scraping Drum/HubThanks all. I just submitted a wa...
- 11:51 AM - uwskier quoted Grandesigner in post Brake Magnet Scraping Drum/HubSince this is the latest thread o...
- 11:50 AM - jkwilson quoted Grandesigner in post Brake Magnet Scraping Drum/HubSince this is the latest thread o...
05-30-2022
- 07:39 AM - Grandesigner quoted cwshelnutt in post Mod of Stereo SystemWe had the same issue because t...
Texas Safety Inspection change...
Today, 11:08 AM in General Discussion