- Tab Content
-
Older Activity
-
04-12-2024, 03:56 PMYou could always purchase a new 1/2" pex fitting and take the washer out and install it in the currently installed fitting. Id say just swap the...10 replies | 760 view(s)
-
04-12-2024, 06:32 AMI used the Bolt It On for 4 dirtbikes in my 399, worked great, i did need to install new floor D rings for where i wanted the bar installed, mainly...8 replies | 304 view(s)
-
04-11-2024, 07:25 PMIts actually a well discussed issue on this forum. The outside diameter of the pex fitting is too small when compared to the inside diamter of the...10 replies | 760 view(s)
-
04-11-2024, 07:19 PMThe white part you see inside is the cone washer, it looks partially crushed. You can purchase the washers and replace without removing the black...10 replies | 760 view(s)
-
04-11-2024, 06:59 PMI would ensure the system is pressurized with water and see if you can determine where the leak originated. Those valves are not uncommon to fail,...10 replies | 760 view(s)
-
04-11-2024, 08:04 AMFT4NOW replied to a thread Parents in towable RVs, how do you keep young kids occupied in the truck for hours? in General DiscussionWe mix it up, sometimes tablets or Nintendo Switch, audio books that we all listen over the truck speakers, coloring books or school activity books.10 replies | 1048 view(s)
About Ranger Rick
Basic Information
About Ranger Rick
- Location:
- SW Idaho
- Interests:
- Camping & Snowbirding
- Occupation:
- Retired
- Serial Number:
- 573FR362XM9909531
- Product Line:
- Reflection Fifth Wheel
- Model Year:
- 2021 Réflection 337RLS
Statistics
Total Posts
- Total Posts
- 38
- Posts Per Day
- 0.05
General Information
- Last Activity
- 01-11-2023 04:56 PM
- Join Date
- 02-16-2022
- Referrals
- 0
No results to show...
No results to display...
02-17-2022
- 10:29 AM - JeffOfBoise quoted Ranger Rick in post New members from Boise, IdahoMy wife and I just purchased a u...
- 06:23 AM - Gold Country Livin' quoted Ranger Rick in post New members from Boise, IdahoMy wife and I just purchased a u...
New Members of the forum.
Today, 10:55 AM in Welcome Mat | New Member Introductions