User Tag List
Thanks: 0
Likes: 0
Results 1 to 9 of 9
-
07-05-2017, 07:04 PM #1
- Join Date
- Aug 2015
- Posts
- 306
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Loose plastic nuts on back of Kantelek water system connecting hose to panel
Luckily I had a water sensor behind the water system on the floor it went off tonight turns out the plastic nuts that connect the hose to the back of the water system panel came loose so I recommend that if you at least have a reflection 317 you check those plastic nuts now and then to make sure they are tight and they did not become loose due to vibration
Sent from my iPhone using Tapatalk
-
07-06-2017, 06:51 PM #2
- Join Date
- Aug 2015
- Posts
- 306
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Does anybody know of a tool that might assist someone tightening the nuts on the back of the novel us because it's tough getting your hands on those nuts
Sent from my iPhone using Tapatalk
-
07-06-2017, 06:52 PM #3
- Join Date
- Aug 2015
- Posts
- 306
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Back of Nautilus sorry spellcheck at it again lol - thanks Bryan
Sent from my iPhone using Tapatalk
-
07-06-2017, 07:42 PM #4
- Join Date
- May 2014
- Location
- NW AL/NE GA Mountains
- Posts
- 2,083
- Mentioned
- 4 Post(s)
- Tagged
- 0 Thread(s)
I use a set of channel lock pliers after I hand tighten them.
And I use gray teflon tape on the threads to minimize any leaks.
Only problem I've had with my 323BHS was in those nylon connections--engineered and built by Grand Design (not Anderson Kantleak). It took me 15 minutes to take'em apart, wrap the threads with gray teflon tape and put'em back together.
-
07-06-2017, 07:44 PM #5
- Join Date
- Aug 2015
- Posts
- 306
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Thanks I will check it out !!!
Sent from my iPhone using Tapatalk
-
07-07-2017, 09:02 PM #6
- Join Date
- Jan 2015
- Location
- Walkertown, NC
- Posts
- 352
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Careful with the channel locks.....broke a fitting using them. Luckily a nearby hardware had two of the fittings.
Marvin & Marion
2016 Reflection 303RLS
2008 Ram 2500HD
[SIGPIC][/SIGPIC]
-
07-08-2017, 08:23 AM #7
- Join Date
- Oct 2015
- Location
- East Tennessee
- Posts
- 29
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I had the same issue recently on my Nautilus panel. Resulted in a very small leak, a minor drip really, that I only found by hearing my water alarm going off. (On a side note, why is it that these alarms only seem to go off at 3:00 AM?) I pulled the panel off and hand-tightened some slightly loose fittings, so far so good. I have to say, after reading all of the horror stories about the Kantleak, I can live with the occasional loose nut on the Nautilus.
-
07-08-2017, 08:32 AM #8
- Join Date
- Aug 2015
- Posts
- 306
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Yeah ours was 8 pm
Sent from my iPhone using Tapatalk
-
07-08-2017, 08:39 AM #9
The black plastic connections are really compression fittings not tapered pipe threads. As such, teflon tape on the threads is not the intended sealing surface. Sometimes the plastic threads will bind before the compression seal is fully compressed. A drop of dishwashing liquid will temporarily lubricate these threads so that you can get a tight seal on the compression ring before the threads bind and you think you have reached sufficient torque/tightness.
RobCate & Rob
2015 Reflection 303RLS
Similar Threads
-
water hose and nautilus system "disconnect" and (why not)... water hoses and filters?
By nctouring in forum General DiscussionReplies: 4Last Post: 09-04-2017, 08:49 AM -
Connecting Satellite Receiver to main TV with RCA Cable
By Jason B in forum General DiscussionReplies: 4Last Post: 01-10-2017, 02:39 PM -
Loose living room slide support bracket nuts.
By anyheading in forum FrameReplies: 0Last Post: 10-26-2016, 09:14 PM -
Loose Furnace Hose
By Kev&Gin in forum Heating and Air Conditioning systems.Replies: 4Last Post: 04-30-2015, 05:32 PM -
Connecting an external Blu-ray DVD to the tv/ entertainment system
By Jchild in forum General Tech TopicsReplies: 3Last Post: 01-26-2015, 11:01 AM
310GK Bounce When Towing
Today, 10:26 PM in Fifth Wheel Hitching Topics