Taking delivery next Friday

[KAR28BH]

Hello all, I'm taking delivery of a new 28BH next Friday. Was about to pull the trigger on an Eagle HT 29.5BHOK, when I saw the 2018 updated to the Reflection.

Any tips for what to check during inspection process. Under slides, trim, roof seals?

I'm planning to install an EMS 50 on this unit, any suggestions on where to locate this on a 28BH?

See you soon at a MI state park.



Sent from my SM-G920V using Tapatalk

[el Rojo]

Congrats and welcome to our group.

Red

[cleazenby]

Congrats and welcome!

[17george]

Congrats welcome to the group

[t&mstr8]

Just saw your post and this may be too late. I mounted the EMS HW50 in an area under the bunk room drawers. There is a hidden open area. I looked at the basement area behind the circuit box but felt it was to cluttered with wires and water lines. Took a different approach that required some work. Removed the paneling in the rear storage area, carefully. Cut the paneling on the inside of the hidden area to access the wiring from the plug. Mounted the EMS in there and routed the remote to the area in the rear storage. Replaced the paneling with a few screws to make it easier to access the EMS for service if needed. You can see this area if you remove the lower drawers in the bunk room.

[KAR28BH]

I thought about mounting it under the bunk drawers, figured I'd find some room there. I'm leaning towards the basement, trying to clean up the electrical while I'm in there. I'd then route the display to right side of the docking station.


Sent from my iPhone using Tapatalk

[dloase]

Congratulations and welcome to the GD family.

[SoccerDad]

Did you by chance take any photos of the area under the bunk room steps? I would love to see them.

Just saw your post and this may be too late. I mounted the EMS HW50 in an area under the bunk room drawers. There is a hidden open area. I looked at the basement area behind the circuit box but felt it was to cluttered with wires and water lines. Took a different approach that required some work. Removed the paneling in the rear storage area, carefully. Cut the paneling on the inside of the hidden area to access the wiring from the plug. Mounted the EMS in there and routed the remote to the area in the rear storage. Replaced the paneling with a few screws to make it easier to access the EMS for service if needed. You can see this area if you remove the lower drawers in the bunk room.

[t&mstr8]

I did but we are out camping and they are on my home computer. However, if you do Facebook, there is a 28BH group that has covered this subject with pictures.

[SoccerDad]

Thank you for that information - I had no idea Facebook could be useful
Since I don't do Facebook I used my wife's account to submit a request to join it. Hopefully we will get accepted right away.
Thanks Again!

I did but we are out camping and they are on my home computer. However, if you do Facebook, there is a 28BH group that has covered this subject with pictures.