Just installed a Splendide washer and dryer in my 369rl. Got the dryer all installed including silicone around the vent outlet. Made some tabs to screw the unit to the floor then proceeded to try to plug in the electric cord. That isn't going to happen. First off I hadn't noticed that only half of the outlet was functional. One plug is blocked off. Then trying to bend the cord to get inserted into the outlet didn't work. My solution at this point is to cut factory cord off and replace it with a flat plug. Learning my lesson I plugged the washing machine before I attempted to slide the unit in. Note: The opening is designed to hold the machine but it does not slide back to the wall as the dryer did. According to the customer service tech I spoke to at the factory you will have about three inches overhanging from the shelf. Suggesting that the electric plugs be moved forward in the opening so you can connect or disconnect them without removing the unit. Going to try to mount the washing machine by making holes in the pan and the floor to match the bolt pattern of the washing machine. I can then bolt it to the floor from the bottom after sealing the pan around the bolt holes.