slides # 1 & 2

[jamesm]

when i try to close my slides 1 & 2 they stick at the top and the bottom comes in at a distressing angle. I then have to grab the top of the trim and pull with my full weight to have it come unstuck. Once it is unstuck it proceeds to come in fine. Is there something i need to put on the seal to have it not stick or is this an adjustment on the bottom that is loose and needs tightening. I have a Reflection 337. Any asisstance to this problem would be appreciated.

[Steve and Cill]

Welcome to the forum James. I'm moving your thread to the Tech Corner so someone from Grand Design will be sure to see it.

Steve

[redram]

Mine does the same thing.Don 303 Reflection

[LBnM]

Sounds like your dealer needs to adjust the slide. Mine work like any other slide I have ever had.

[GDRV Service]

when i try to close my slides 1 & 2 they stick at the top and the bottom comes in at a distressing angle. I then have to grab the top of the trim and pull with my full weight to have it come unstuck. Once it is unstuck it proceeds to come in fine. Is there something i need to put on the seal to have it not stick or is this an adjustment on the bottom that is loose and needs tightening. I have a Reflection 337. Any asisstance to this problem would be appreciated.

Hi @jamesm,

Please send me a private message (PM) with your contact information (including a phone number where you can be reached) and the 17-digit VIN of your Reflection 337 RLS. We'll have someone from our Customer Service technical assistance group give you a call to walk you through your concerns.

Best regards,
~ Janice

[GDRV Service]

Mine does the same thing.Don 303 Reflection

Hi Don (@redram),

Please see my reply above to @jamesm, and feel free to send me a PM with your contact and VIN information if you would like a call back from someone in our Customer Service department.

Best regards,
~ Janice