Additional Tail Lights

[Steven@147]

Remember this photo when the guy tore off the rear wall? I wish I could get to somewhere near the top lights.

Attachment 14284Attachment 14285

Holy Crap!

I too would like to add additional tail lights.

[mbaker]

I used these Rob, and they work great, very bright. All my inside and outside lights are LED now.

https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

Ben

[Steven@147]

I like it, I assume you were just able to fish line up through the insulation to the other lights? I hope to add one much higher up the rear wall for ours because the bikes block ours ever so slightly but wasn't sure how easy that would be. I already switched the lights out to LED units which are significantly brighter.

guys I like the additional visibility aspect as well. Your installations look like it came from the factory that way! When your back end lights up it gets the attention of people following you.
Even on our Imagine the tail lights seem small. Would have to find some that looks exactly like the originals to make it look right. Possibly through the dealer.

E-trailer has them for our Imagine part number RVSTB60 $6.25 Here is my installation.

[JCZhome]

JCZ, I think from your earlier posts about this, that the Momentum had a wider sidewall construction where the Reflection is narrow above the rear tables. This made fishing wires more difficult. I don't know if a solution was ever found. Would be nice to have those higher lights.

Yes, the Momentum 376TH and the Solitude 374TH both have the wide side walls, due to the narrower garage. I have seen other brands of toyhaulers that have the full width garage with the LED lights like mine, at the very edge of the frame of the garage door, however, I've not saw them on the full size Momentums.

I will be at the rally at Black Oak Casino in Nov. Are you going to be there?

[Gold Country Livin']

Yes, the Momentum 376TH and the Solitude 374TH both have the wide side walls, due to the narrower garage. I have seen other brands of toyhaulers that have the full width garage with the LED lights like mine, at the very edge of the frame of the garage door, however, I've not saw them on the full size Momentums.

I will be at the rally at Black Oak Casino in Nov. Are you going to be there?

Yes, we will. Look forward to seeing you! Will be there Nov 1st I believe.

[Bogeyman]

Momentum 349m (2019).

Does anyone know how the wires are routed to the tail lights?
In particular, the left (driver's) side? I have no flasher for left turns. The light works, just no flasher.

Note: I *HAVE* tested the light itself - it is fully functional.

[Mikec557]

Remember this photo when the guy tore off the rear wall? I wish I could get to somewhere near the top lights.

Attachment 14284Attachment 14285

You know how it is. You're searching and reading in the DIY section because you've got a project or a plan and you want more info. Then you see something else that interests you and you follow that for awhile. Then you see a train wreck you just can't take your eyes off of...

What the heck happened to the back wall and do you have a link to the original source/story?

Mike

[gbkims]

You know how it is. You're searching and reading in the DIY section because you've got a project or a plan and you want more info. Then you see something else that interests you and you follow that for awhile. Then you see a train wreck you just can't take your eyes off of...

What the heck happened to the back wall and do you have a link to the original source/story?

Mike

Back falloff - https://www.mygrandrv.com/forum/show...9-Back-falloff

[Mikec557]

Back falloff - https://www.mygrandrv.com/forum/show...9-Back-falloff

Thanks Gene. Like a train wreck, I couldn't take my eyes off it until the final page. On the upside, I did see where the taillight wires are located. :-O

[Cookieamt]

Hi, I am attempting to add extra tail lights to my 2018 Momentum 351m. I have the wide garage which leave narrow sides to put the lights on. I tried to fish tape from the predrilled hole the had a plastic plug in it down to the taillight wiring but found that the bottom of my rig is solid with the frame. I even tried running the fishtape up the side near the back corner and ran into more frame. See pics for reference. Anyone have any suggestions on how I can get these wired up and attached high enough so that the boneheads behind us can see us. I am a disabled vet that doesn’t have a lot of strength, but not afraid to try to better our 5th wheel. TIA




Cookie Koch
2018 Ram Limited DRW Diesel
2018 Momentum 351m