Suburban Water Heater Doesn’t Work On Gas – Need Water Heater Wizard Help

[raingurl]

The problem with the water heater not working on propane turned out to be caused by the GAS rocker switch in the control center. The switch wouldn’t work when pressing it ON or OFF, as one would normally do. I found that if the switch was pressed and held “almost on” then the light would come on in the switch and I got it to stay on. Then the DSI fault light came on and I was able to get the water heater to fire up, as it should. Several of the switches in in my control center behave the same way. Looks like some switch replacement in the future. Thanks for the responses.

I've been using water heaters back in the day and had periodical troubles as you mentioned. Changed several models and they all didn't seem like an optimal option. As for me, there's no better thing to heat up then good old kerosene heater. I personally use the one from Dyna manufacturer. Serves me well for more than 5 years now.

[Thesheetster]

I am having the same problem on my 2019 351M but it has the touch screen. When I turn on the gas heater I can hear a click behind the cabinet but I don't get any power to the circuit board, temp switch or the gas valve. I can't figure out where I'm losing the circuit, is there a fusible link somewhere??

[Ynot4me2]

I am having the same problem on my 2019 351M but it has the touch screen. When I turn on the gas heater I can hear a click behind the cabinet but I don't get any power to the circuit board, temp switch or the gas valve. I can't figure out where I'm losing the circuit, is there a fusible link somewhere??

Your replying to an older thread, best to start a new one for you specific problem and model. I'm assuming that you verified the A/C breaker, 12v fuse in the fuse panel the on the control board on the unit itself?

[Thesheetster]

I can't figure out how to post my own thread.

[Second Chance]

I can't figure out how to post my own thread.

Go to the appropriate subforum (for the topic you want to post about) and click on the "+Post New Thread" button at the top left.

Rob