User Tag List

Thanks Thanks:  0
Likes Likes:  0
Page 1 of 2 12 LastLast
Results 1 to 10 of 11

Thread: Fridge problems

  1. #1
    Site Sponsor
    Join Date
    Feb 2019
    Location
    Hillsborough, NC
    Posts
    47
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Fridge problems

    Hello, has anyone had problems & solutions with their dbl door Dometic refrigerator? Mine will not switch to gas when disconnected nor will it come on with the LP button pushed in. Other words it will not run on lp. Both LP tanks with plenty of gas & have used the stove serveral times so their is LP gas in lines.
    Help?!
    JP

  2. #2
    Site Sponsor
    Join Date
    Feb 2019
    Location
    Hillsborough, NC
    Posts
    47
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Sorry...this is in a 2019 reflection 303rls

  3. #3
    New Member
    Join Date
    May 2019
    Location
    Southern Utah
    Posts
    19
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Is it in a popout? If so, the propane cable on the bottom of the popout, which is rubber, should have a brass fitting with a small on-off lever. Could it be off?

  4. #4
    Site Sponsor
    Join Date
    Feb 2019
    Location
    Hillsborough, NC
    Posts
    47
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Could not find a cut off lever, just rubber gas line.

  5. #5
    Site Sponsor Superduty's Avatar
    Join Date
    Oct 2017
    Location
    Michigan
    Posts
    327
    Mentioned
    1 Post(s)
    Tagged
    0 Thread(s)
    On my 18, 303. The valve shut off is around the dump pipe. A little lever on the side of a brass quick disconnect.
    It is not under the side.
    2018 Reflection 303. #16847.
    2nd AC, Table & Chairs.
    2013 Ford 6.7, CCSB 4x2. 3:31 axle

  6. #6
    Site Sponsor GeoffnCheri's Avatar
    Join Date
    Oct 2017
    Location
    NW Arkansas -
    Posts
    282
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quote Originally Posted by Jerry P View Post
    Hello, has anyone had problems & solutions with their dbl door Dometic refrigerator? Mine will not switch to gas when disconnected nor will it come on with the LP button pushed in. Other words it will not run on lp. Both LP tanks with plenty of gas & have used the stove serveral times so their is LP gas in lines.
    Help?!
    JP
    Jerry,
    I experienced a similar issue this weekend which was not related to the propane. My battery disconnect was in the off position and not powering the refrigerator. Off position means batteries off and not battery power to the fridge. On position means power.
    Geoff and Cheri
    2011 F250 CC 6.7L
    Pull Rite 16k SuperGlide
    2018 Reflection 303RLS, Build date 9/2018
    USMC-Ret
    Maintaining the Thin Blue Line

  7. #7
    Site Sponsor
    Join Date
    Feb 2019
    Location
    Hillsborough, NC
    Posts
    47
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Ok, I'll check. Thanks!

  8. #8
    Site Sponsor
    Join Date
    Feb 2019
    Location
    Hillsborough, NC
    Posts
    47
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Off position meaning you can remove the key...on position meaning the key is locked in place & cannot be removed, correct?

  9. #9
    Site Sponsor GeoffnCheri's Avatar
    Join Date
    Oct 2017
    Location
    NW Arkansas -
    Posts
    282
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quote Originally Posted by Jerry P View Post
    Off position meaning you can remove the key...on position meaning the key is locked in place & cannot be removed, correct?
    Correct. There are some folks on this forum who are much more knowledgeable than I, but I would check this and the current battery charge level. Others will likely chime on how to check the circuit board or controller if this does not correct the issue
    Geoff and Cheri
    2011 F250 CC 6.7L
    Pull Rite 16k SuperGlide
    2018 Reflection 303RLS, Build date 9/2018
    USMC-Ret
    Maintaining the Thin Blue Line

  10. #10
    New Member
    Join Date
    Apr 2019
    Location
    WA
    Posts
    1
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    I had the same issue with my new Imagine 2670 MK. If you have been operating on electrical power, and the the refer temp is low enough, the gas operation will not start until the temperature rises above the set point. The gas supply indicator light will not turn on until the gas is actually needed to run the refer.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

DISCLAIMER:This website is not affiliated with or endorsed by Grand Design RV, LLC or any of its affiliates. This is an independent site.