User Tag List
Results 1 to 9 of 9
-
06-08-2019, 08:24 AM #1
- Join Date
- Nov 2017
- Location
- Avon Lake, Ohio
- Posts
- 69
- Mentioned
- 3 Post(s)
- Tagged
- 0 Thread(s)
Sagging Coroplast and Surface Rust
1. I noticed the coroplast is sagging and open on the front-end of my undercarriage. I think I may be catching air (hoping I am not catching water spray) and am afraid of it getting worse. I also noticed surface rust is growing. I am thinking of unbolting coroplast along the front and trying to run a strip of something rigid (metal/plastic) to hold it up and seal it. I will simply use the same bolt pattern to hold up the strip — any suggestions on material? Anyone done something like this before? 2. Surface rust, any tips for treating before it gets worse. See pics. Also seeing it under pin box. I also am seeing it on the frame where the suspension is. I am nervous about welds being affected. Ideas to address?
Last edited by Andy+Mo; 06-08-2019 at 08:41 AM.
-
06-08-2019, 09:53 AM #2
- Join Date
- Oct 2016
- Posts
- 1,539
- Mentioned
- 13 Post(s)
- Tagged
- 0 Thread(s)
I'm using this product
http://www.corroseal.com/
Requires a surface free of oil/grease, dirt and loose rust. I'm nearly finished brushing on the entire frame, axles and suspension. Need to make sure a nice thick coat is applied. It turned rust to black magnetite within an hour or so. Etches the existing paint providing a primer coat. Water based, easy clean up, not toxic. Well, you can't drink it or inhale it if you spray it. Can be sprayed with an undercoating gun I suppose, haven't tried that. I'm pretty impressed with it so far.
Looks like you've got a bit of a scoop up front that could have collected road spray. I'd drop that coroplast far enough to check for wet insulation if there's any there. I sealed the leading edge of my coroplast by adding some more screws and washers, then applying 4 inch Gorilla tape after ensuring the surface was clean.
-
06-08-2019, 10:32 AM #3
I've had success with Rustoleum Rust Reformer on surface rust. Spray it on, it dries black and then paint over it.
Sent from my SM-G950U using Tapatalk2023 Momentum 398M-R
2023 Ford F-450
SOLD - 2021 Reflection 311BHS
SOLD - 2017 Momentum 399TH
-
06-09-2019, 08:52 PM #4
- Join Date
- Aug 2018
- Posts
- 127
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
After dropping the coroplast it is hard to get it back up without a few wrinkles. I’ve used a few short pieces of aluminum flat plate to flatten the wrinkles and 5 aluminum channel pieces along the length. I used 11/2 inch self tapping screws as the originals are not long enough. Also caulked both coroplast edges the full length each side to seal it and attacked all signs of rust with black rustoleum paint. The only head scratcher now is how will I detect a water leak. I thought of putting a couple of round 1/2” drains in the middle of the coroplast but thought of it too late.
Last edited by chillybob; 06-09-2019 at 08:55 PM.
-
06-16-2019, 07:09 PM #5
- Join Date
- Nov 2017
- Location
- Avon Lake, Ohio
- Posts
- 69
- Mentioned
- 3 Post(s)
- Tagged
- 0 Thread(s)
Thanks for the input men. Looks like I have some good options here.
-
06-16-2019, 08:08 PM #6
- Join Date
- Dec 2016
- Posts
- 1,201
- Mentioned
- 5 Post(s)
- Tagged
- 0 Thread(s)
Rust converter, spray paint over the rust. I do it twice a year, if you keep up with it there isn't much to do after the first couple of times. Same with the exterior bolts and screw heads, they rust out as well because they use cheap stuff.
https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=12019 Momentum 395
2018 Ram 3500 DRW 4.10 AISIN
-
06-17-2019, 04:55 AM #7
I use Rust Reformer as well, but i brush it on rather than the spray, some have said the spary is not as effective.
MarkMark & Cindy, York, PA
2018 Reflection 150 Series 230RL (White)
Curt A16 Hitch, Turning Point Swivel Pin Box, set to Swivel, with Curt Wedge
2019 Ford F250 STX 6.2L with 4.30 Gears, SB CC SRW 4x4, 18" Wheels, 3192 Payload, 15,000 Towing Capacity, Fifth Wheel Prep & Camper Package, Ultimate Trailer Tow Camera, Factory Ordered
Prev TV: 2016 F150 3.5L Supercab with 6.5' bed, 2167 payload, LT Tires, and Air Lift 5000 air bags set to 15lbs
-
09-22-2019, 02:46 PM #8
- Join Date
- Nov 2017
- Location
- Avon Lake, Ohio
- Posts
- 69
- Mentioned
- 3 Post(s)
- Tagged
- 0 Thread(s)
Finally fixed sagging/scooping Coroplast. I bought a solid piece of exterior vinyl/pvc trim, bevel cut it and bolted it on with significant overlap of the Coroplast. Prior to bolting on the trim I sanded off all loose rust, coated the whole area with Corroseal rust converter and then coated it with Rustoleum. Cleaned up nice. Thanks for all the helpful advice.
2015 Dodge Ram 2500; 2017 Reflection Fifth Wheel 303RLS
-
09-23-2019, 11:45 AM #9
- Join Date
- Aug 2018
- Posts
- 127
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Looks to be a fine fix and excellent job!
2024 Grand Design Transcend 235BH...
Today, 04:39 PM in Plumbing and Water Systems