User Tag List
Results 11 to 15 of 15
Thread: Weboost Rv cell phone mod
-
08-14-2019, 01:01 PM #11
- Join Date
- Jun 2019
- Posts
- 492
- Mentioned
- 2 Post(s)
- Tagged
- 1 Thread(s)
-
08-14-2019, 01:06 PM #12
- Join Date
- Jun 2019
- Posts
- 492
- Mentioned
- 2 Post(s)
- Tagged
- 1 Thread(s)
I didn't think about the cheap coaxial in the camper. Might mount it in the rear with the suction cup. Once the suction cup is engaged, there is no removing it.
-
08-14-2019, 03:16 PM #13
- Join Date
- Jun 2019
- Posts
- 492
- Mentioned
- 2 Post(s)
- Tagged
- 1 Thread(s)
Reply from Weboost.
Customer Service (weBoost)
Aug 14, 2:47 PM MDT
We do not recommend using the existing cable, because the cable that is pre installed in RVs for TVs sometimes are not rated for cellular frequencies and can cause either feedback in the booster system or can cause the right frequencies to not be boosted. That is why we recommend using the cabling that comes in the kit with the booster.
-
08-21-2019, 03:51 PM #14
- Join Date
- Jul 2019
- Posts
- 3
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I have been using WeBoost for a while. I run the cable through the slide edge, the slide has to be in just a little to get the cable in then extend out to seal. Works fine. Also on a extendable pole.
-
08-21-2019, 04:12 PM #15
- Join Date
- Jun 2019
- Posts
- 492
- Mentioned
- 2 Post(s)
- Tagged
- 1 Thread(s)
Victron 100 amp Autotransformer...
Today, 12:14 AM in Electrical System and Wiring