User Tag List
Results 11 to 17 of 17
-
08-31-2019, 03:50 AM #11
- Join Date
- Oct 2018
- Posts
- 19
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Well I started the build. Took me all day to run the two 6/2 wires from the hutch to just under the pass-through. Those are some big wires. I ran the wire along the other wires most of the way. When I got closer to front of trailer I couldn’t get wire through the floor beam. To many wires and hoses in and they filled the rest with insulation foam. Note to anyone else doing this buy a lot of wire. I purchased 40 feet of wire thinking 20 feet for input and output would be enough. It is Just enough. I have the pass-through wall cut and felt installed. It’s 7/16 osb and hope it is strong enough to hang the 50 pound inverter on. Tomorrow I will drill a hole in pass-through floor near by the nautilus panel. I plan on hanging the inverter right next to it. I’ll layout and attach all the components to wall. I’m still not sure how or where I’m bringing down the solar wires. I’m still thinking about drilling a hole in the roof and brining down closet wall. I’m just not sure how to find the right spot on roof to drill.
2019 Reflections 315RLTS
2005 F250 Powerstroke Bulletproofed
2014 HD FLHTK
-
08-31-2019, 06:34 AM #12
- Join Date
- Mar 2017
- Location
- Pearland, TX
- Posts
- 1,709
- Mentioned
- 15 Post(s)
- Tagged
- 0 Thread(s)
When I drilled the hole in my roof, I had a small area to pick from, so I checked below & above where I thought my hole should be.
Drilled a small pilot hole up from below using 12" long drill bit (aircraft bit), then used hole saw thru the roof, and then thru the ceiling.
Closet location sounds a bit like TusconJim did in his 297RSTS where he used laundry closet: https://www.mygrandrv.com/forum/show...r-Installation- Gene
Kim & Gene
2015 Reflection 317RST
2017 Ram 3500 CC LB 4x2 6.7 CTD AISIN 3.73 DRW Auto Level Rear Air, BD3, Prodigy P3, Aux Tank
-
08-31-2019, 09:09 AM #13
- Join Date
- Oct 2018
- Posts
- 19
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Hanks for the link. The front closet does have the plumbing for a washer. There is no way to drill a pilot hole from bottom if i try and bring the wire down through the wall. I have a bore scope I will use to see what is in wall. Bringing down the outside wall might not be to bad.
2019 Reflections 315RLTS
2005 F250 Powerstroke Bulletproofed
2014 HD FLHTK
-
08-31-2019, 04:43 PM #14
Looks familiar, you posted this on the Solar-powered Grand Design Facebook group right?
Resistance is Not Futile, It's Voltage Divided by Current.
-
09-02-2019, 10:23 PM #15
- Join Date
- Oct 2018
- Posts
- 19
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
-
09-07-2019, 07:46 PM #16
- Join Date
- Oct 2018
- Posts
- 19
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
-
09-12-2019, 10:29 PM #17
- Join Date
- Oct 2018
- Posts
- 19
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
310GK Bounce When Towing
Today, 02:16 AM in Fifth Wheel Hitching Topics