User Tag List
Thanks: 0
Likes: 0
Results 1 to 1 of 1
-
11-04-2019, 07:17 AM #1
- Join Date
- Apr 2017
- Location
- Where the road leads
- Posts
- 1,356
- Mentioned
- 5 Post(s)
- Tagged
- 0 Thread(s)
Kitchen slide bulb seal on inside and the tape
Looking for advise. 1st the issue then what I have done.
While parked long term last winter under pine trees some sap must have been left on top of kitchen slide. I noticed the interior bulb seal at the top came off the track. Popped it back on to get to our workcamping gig for 6 months......the last couple weeks have been moving a lot and tried a quick fix...
I took seal out and wiped clean and 303'd it. Then I cleaned up any residue on top of the slide. This is on the inside edge.
What I noticed was the tape going along the edge got rolled up some and was adding to the stickiness. I cleaned up the residue and ran a piece of duct tape about 2 feet to help......duct tape was rolled back in 1 spot.
So either I missed some residue, or duct tape was a bad idea (I do have the black roof tape if better to try).....or both
So, do I try carefully cutting out the rolled up tape and use the black roof tape? Best residue cleaner? Used wd40 and dawn.....
Do I put a small thin plate of some kind......I am at a Habitat build in Blacksburg VA for 2 weeks....
Thanks....Jim and Belinda H. Pa.
2018 337RLS- 2nd ac, dual pane windows, table and chairs, Kodiak disc brakes 12-28-17 (Thanks Ed!)
Charging Lithium Batteries From...
Today, 08:27 PM in Electrical System and Wiring