User Tag List
Results 11 to 14 of 14
Thread: 2020 2800BH Ground Control TT
-
05-13-2021, 07:32 PM #11
- Join Date
- Jun 2016
- Posts
- 256
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
-
09-12-2022, 07:28 AM #12
- Join Date
- Sep 2021
- Location
- Minnesota
- Posts
- 4
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
This thread seems like it may be dead...but just in case folks have done the Ground Control on the 2800bh, I have two questions -
1. How did you handle the plumbing that runs under the frame from the front tank?
2. Anyone have photos of the install on a 2800bh?
-
09-12-2022, 08:47 AM #13
- Join Date
- Sep 2019
- Posts
- 6
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I did have to modify the plumbing to clear the cross brace and jack. It didn't take much but had to be done. I just cut the pipe where it intercepted and routes it around the jack. I then braced it to the cross support. It just took a few of 90 degree joints and a little bit of pipe. Works fine.
I don't think I have any meaningful photos of the installation. It's pretty straight forward. I do wish the rear jacks were a bit lower to the ground and the front jacks were a bit higher off the ground. At some point I might consider adding a small lift kit to the suspension then spacing the rear jacks down a bit to get them closer to the ground. But it works fine as is.
-
09-13-2022, 06:38 AM #14
- Join Date
- Sep 2021
- Location
- Minnesota
- Posts
- 4
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Thanks for the detail!
Do you still have the trailer? If ya do, would you snap a few (well, lots if possible!) photos of the install?
Nightmare
Today, 05:32 AM in General Discussion