I wanted an easy way to mount and remove an outdoor grill that we purchased from Sams Club. We love the grill, but have found it difficult to mount it in many situations. We usually end up settling on a table. I decided to cut a square hole in the end of the 2" receiver bar end bracket and pound in a 1 1/2" to 2" adapter receiver. I then took some 2" bar and cut some angles and welded it together. I then mounted a bumper vice that is adjustable in height and welded some angle iron. In the end, the grill sits nicely and I can open and close the rear door easily and it's far enough away to be safe. it folds down into two pieces that lay flat. Easy to install and take down... in about 1 minute. Also, tapped into the rear LP line to hook up the quick disconnect and all good to go!

Wanted to share.

MattClick image for larger version. 

Name:	IMG_7951.jpg 
Views:	21 
Size:	1.97 MB 
ID:	24682Click image for larger version. 

Name:	IMG_7954.jpg 
Views:	20 
Size:	1.76 MB 
ID:	24683Click image for larger version. 

Name:	IMG_7904.jpg 
Views:	21 
Size:	1.11 MB 
ID:	24684