Blank tank flush relocation

[GD350M]

Quick Note: Never use your fresh water hose to flush your black tank. just a good rule of thumb.

I never said I was using my fresh water hose to clean my black tank. I have a hose specifically for the black tank only. It doesn't get used to even wash my rugs.

[BennyJR]

I never said I was using my fresh water hose to clean my black tank. I have a hose specifically for the black tank only. It doesn't get used to even wash my rugs.

Did not mean to insinuate you were using your fresh water hose to flush your black tank. It was just a tip for those who happened to read your thread and may not have known that. Lots of newbys out there.....Including myself.

[GDRV Service]

Could you look to relocate were you put the main blank tank flush connection in the storage compartment of at least the 350M? I not sure what the other compartment hookup areas look like, but on my 350M you have the black tank flush connection at the very top of the hookups. This is a problem area as water does drip from there as you are flushing the black tank and drips right down on top of the fresh water connection. This can cause cross-contamination with the fresh water system. I would like to have mine fixed as well, so that we don't inadvertently get sick from this.

Hi Stephen & Nikki (@GD350M),

We will look into this. As stated in the posts above, there is a one-way check valve in the black tank flush line, and with the gate valve open during flushing cross contamination is not likely. We are in the process of redesigning the utility center control panel on the M-series, and will take your concern into consideration.

Best regards,
~ Janice