bent foot on stabilizer

**BrangiesAdventures** · 03-10-2020, 01:26 PM

Hey folks, while auto-leveling today, the mid stabilizer hit some soft mud and bent the foot, the flat disc on the bottom. How easy is it to replace and where do i get the part. Thanks

**Jerryr** · 03-10-2020, 03:27 PM

Mine back one bent once. I took the pad off, out it in a vice and bent it back.

If that doesn’t work a call to Lippert at 574-537-8900 should be able to buy a new pad

**Second Chance** · 03-10-2020, 04:09 PM

They're readily available on Etrailer and Amazon.

Rob

**powerscol** · 03-11-2020, 09:57 AM

Or - find a good welding shop and have it bent back and reinforced.

**D2Reid** · 03-11-2020, 10:36 AM

There is a big bolt on the underside of the pad. Some RV dealers stock them, if not they can order one. If you look closely at mine you will find one different from the others. If you don't have it with you for the match check the diameter.

I am kind of a red neck. I would put a 2x4 under the lower bent part and run the jack down in manual mode on top of it and bend it back. It will be wrinkled, but it will still work.