User Tag List
Thanks: 0
Likes: 0
Results 1 to 7 of 7
-
06-15-2020, 01:17 PM #1
- Join Date
- Aug 2018
- Posts
- 62
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Slide Out Rollers - Can Someone Please take a look at theirs for me?
Need a favor...I have an issue with my 2019 351M living room/camp side slide floor bowing up on the outside when fully retracted. This leaves only the center 2 rollers touching the floor, and one is gouging the linoleum.
I found that my kitchen slide "rolls" in and then all 3 rollers lift off the floor a bit when it pulls all the way snug. The floor stays flat with now bowing.
Can someone please take a look at their and let me know what they find? Trying to understand what is normal and which side is doing what it is supposed to.
Thanks!
-
06-16-2020, 06:14 AM #2
- Join Date
- Jan 2020
- Posts
- 124
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I have the same unit, i will try to get some info for you but it willbe later this evening
Sent from my SM-G960U using Tapatalk
-
06-16-2020, 07:38 AM #3
- Join Date
- Aug 2018
- Posts
- 62
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
-
06-19-2020, 03:23 PM #4
- Join Date
- Aug 2018
- Posts
- 62
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
-
06-21-2020, 07:59 AM #5
- Join Date
- Jan 2020
- Posts
- 124
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Hey, sorry it took so long....been real busy. Just pulled slide in, from whst i can see, the rollers are very slightly above the floor in the middle and the two outers are just touching. Mine leaves a witness mark on the floor sometimes
-
06-21-2020, 12:23 PM #6
- Join Date
- Aug 2018
- Posts
- 62
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
-
06-21-2020, 04:38 PM #7
- Join Date
- Jan 2020
- Posts
- 124
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
The slide out can be adjusted out at the arms where they connect to the slide itself. Up and down using a jack bolt and loosening the 4 flange bolts. Might be able to adjust it to make it better
Sent from my SM-G960U using Tapatalk
Frame Flex
Today, 07:32 AM in Frame