User Tag List
Results 11 to 20 of 34
-
07-16-2020, 03:05 PM #11
- Join Date
- Jun 2020
- Location
- Temecula, Ca
- Posts
- 64
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
That's good advice and I'll get the manuals this afternoon. I've called a mobile RV shop to take a look at it and he's due here tomorrow afternoon. Hopefully, he'll know more about this than I do...or I'm in big trouble
Thanks for your help and advice.
Ron
-
07-16-2020, 04:36 PM #12
- Join Date
- Apr 2017
- Location
- Fort Collins, Colorado
- Posts
- 1,305
- Mentioned
- 26 Post(s)
- Tagged
- 0 Thread(s)
The control board runs on 12V DC. The one control board runs both the 120v AC heaters (if on electric) and the LP gas controls (igniter, gas valve). The temperature sensor and protection is/can be comment to both the electric heater element and the LP gas side. So yes, there are common components to the two different heating methods.
ChrisChris & Karen
Fort Collins, CO
2017 F-350 SRW 6.7 Lariat Value CC LB 4x4
2018 Solitude 310GK - Sold 7/2023
-
07-16-2020, 04:44 PM #13
- Join Date
- Aug 2015
- Location
- Northern CO & SW Florida
- Posts
- 126
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I'm gong to assume this is a Suburban HWH? I also assume you checked the 12 volt fuse and 110 circuit breaker as well as the small switch on the outside (110 Volt)
On the front of the unit on a black cover there are two rubber looking disks. These are the resets for 110V and the other for 12VDC. Try pushing in on both of these....push real easy because the reset is minimal and it's hard to feel if they reset. Before you lost the HWH was the water like REALLY hot?
Mark2014 HDT Volvo 780 "Baby Bird"
2016 Smart Car "Baby Bird Turd" - on the back
2020 Momentum 376THS
We're both proud USAF Retirees...
-
07-16-2020, 10:52 PM #14
- Join Date
- Jun 2020
- Location
- Temecula, Ca
- Posts
- 64
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
The water heater is a Dometic but I don't have the model number in front of me. I"m going to have to wait until tomorrow morning to get the model number off the plate. I can tell you that the paperwork they included in the new owners package is nothing like the heater that's actually in the trailer. Very frustrating. I'll post more info tomorrow once I get the correct information.
Thanks,
Ron
-
07-17-2020, 12:23 AM #15Rob & Nikki + Cloverfield
2020 Grand Design Solitude S-Class 3350RL
2015 RAM 3500 Longhorn Laramie Crew Cab, Long Bed, 4x4 Dually Cummins/AISIN
Mountains of Pennsylvania
-
07-17-2020, 04:54 AM #16
- Join Date
- Apr 2018
- Location
- The Independant State of Alberta
- Posts
- 710
- Mentioned
- 8 Post(s)
- Tagged
- 0 Thread(s)
-
07-17-2020, 02:37 PM #17
- Join Date
- Jun 2020
- Location
- Temecula, Ca
- Posts
- 64
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
It was the thermostat. Trailer is all of 6 weeks old...pretty sad. Thanks to everyone that offered suggestions/recommendations. Greatly appreciated.
-
07-17-2020, 02:42 PM #18
-
07-23-2020, 11:47 AM #19
- Join Date
- Jun 2018
- Posts
- 2
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I had the exact same issue on my 28BH, the cause was a bad connection on the water heater thermal cut off diode (small wire with spade ends) To diagnose, I turned the Water Heater in propane mode and electrical off then wiggled the diode a little to make better contact and once it made proper contact the propane burner would ignite. Remove the diode and gently tighten the female crimps with pliers and reinsert.
-
07-23-2020, 12:55 PM #20
- Join Date
- Dec 2019
- Location
- Outside Pinehurst NC
- Posts
- 268
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
New Grand Designer Owner to be
Today, 01:11 AM in General Discussion