User Tag List
Thanks: 0
Likes: 0
Results 1 to 8 of 8
Thread: Momentum 29G Ramp Fasteners
-
09-03-2020, 05:53 AM #1
- Join Date
- May 2020
- Location
- Florida Panhandle
- Posts
- 37
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Momentum 29G Ramp Fasteners
FYI: I was walking around my 29G and happen to notice that 3/4 of the bolts that fasten the ramp to the frame were loose, if this happens you will need two people to tighten them up. I may take each out at a time and apply some Loctite.
Shortleggs
-
09-03-2020, 06:03 AM #2
- Join Date
- May 2020
- Location
- Smyrna TN
- Posts
- 69
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Originally Posted by [email protected]Neil and Joyce Anderson
2021 Grand Design Momentum 29G
2010 F350SD Dually / 2019 Harley Ultra Limited (Mine) / 2016 Harley Street Glide (Wife's)
Might get to retire someday if we ever stop spending money!!
-
09-03-2020, 06:21 AM #3
- Join Date
- May 2020
- Location
- Florida Panhandle
- Posts
- 37
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Some of these bolts I could turn with my fingers, knew that wasn't good so if you can put a socket on it and it spins there is a faster on the inside(not sure what it's called) that uses a star bit to tighten. I would check all fasteners !
-
09-20-2020, 10:50 AM #4
- Join Date
- Sep 2020
- Posts
- 11
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I have the 28 g and same do you open the belly plastic to access the inner nut I lost one bolt already
-
09-20-2020, 03:54 PM #5
- Join Date
- May 2020
- Location
- Florida Panhandle
- Posts
- 37
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Kpopplet, the inner faster should be located inside garage area where the ramp meets the trailer. Looking from the rear, ramp closed, the bolts that go through the upper part of the spring hinge but I would check all.
-
09-20-2020, 03:55 PM #6
- Join Date
- May 2020
- Location
- Florida Panhandle
- Posts
- 37
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
should not have to loosen underbelly!
-
09-20-2020, 07:31 PM #7
- Join Date
- Sep 2020
- Posts
- 11
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
The bolts loosening on mine are to the frame not ramp door I didn’t read op’s post close enough
-
09-21-2020, 06:44 AM #8
- Join Date
- May 2020
- Location
- Florida Panhandle
- Posts
- 37
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Kpopplet, I haven't checked the lower bolts and just looked and there is plastic underbelly cover from the fuel cell to the rear so you may need to take that off or at least remove the most rearward screws and a few on each side of plastic.
Freezer Opens on Travel Day?
Today, 03:46 PM in Appliances