2021 Imagine XLS Changes

[NTents]

We decided to place our order for our 21BHE 3 weeks ago and expect to see it sometime in January. Here are the changes we were told to expect compared to the 2020:
-Solar prep on rooftop, wire loop in pass thru to install controller etc.
-Backup camera already installed
-Queen mattress upgraded to 12" memory foam
-TPMS equipped
These changes are going to save us several hundred bucks plus install time. Great news!

Mike

[Ynot4me2]

We decided to place our order for our 21BHE 3 weeks ago and expect to see it sometime in January. Here are the changes we were told to expect compared to the 2020:
-Solar prep on rooftop, wire loop in pass thru to install controller etc.
-Backup camera already installed
-Queen mattress upgraded to 12" memory foam
-TPMS equipped
These changes are going to save us several hundred bucks plus install time. Great news!

Mike

Wow, I had heard about the roof solar prep but not the rest. If yours was built after August, you'll also have the Compass Connect control panel.

Sent from my SM-T580 using Tapatalk

[Ynot4me2]

Oh and welcome to the gang.

Sent from my SM-T580 using Tapatalk

[Jammer]

The TPMS addition is just the pre wiring for the lippert tire linc system. There is still need to purchase the extender and monitors to snap into the wired dock. https://www.amazon.com/Lippert-Compo...NsaWNrPXRydWU=

[bryanpdaugherty]

We Have a 2021 22MLE with the tire linc tpms prep. Where is the wired dock on the rig?


Sent from my iPhone using Tapatalk

[Jammer]

On my 2500rl it’s in the storage pass thru by the hookups.

[MattyC]

Good morning all! We just purchased a 2021 21BHE. The rooftop does have the solar prep. the back up camera prep is there, but I had to purchase the camera and install it. The TPMS is prepped, but not included. Our mattress was not a memory foam, but my wife added memory foam to the mattress and it works great! Happy to help with other questions if needed.

[jay21bhe]

does anyone know how the wires are run for the pre-wired TireLinc ? i tried to connected a new repeater but it seems there is no power to the "dock". I unscrewed the dock but can only pull the wire about 10 inches.. I was hoping to atleast have gotten to the in-line fuse, but no luck.. is there an easy way to check this wiring?

my new repeater is operational as i connected it with a 9v battery and got the status light to come up right away.

Thanks,