310GK with Superglide and Morryde

[brandtb1919]

I am about to pick up my 2021 310GK for the first time, and was wondering if anyone has had experience with my setup.

I have a 2019 F350 short bed with a Pullrite Superglide, and the 310 has the Morryde pinbox.

Has anyone had any issues with the bed rail clearance? The Superglide does not have any height adjustment in it, but I believe there is some in the pinbox.
Most of what I have read says 5-6 inches is the minimum as long as the trailer is level. This is my first fiver, I've had TTs for years.

It would certainly put my mind at ease if someone has some measurements and experience to share.

Thanks!

[huntr70]

Haven't seen any issues with that combo.

[brandtb1919]

Thanks for the input Steve. I would imagine being at an RV dealer, you see every combination of vehicle/trailer.

Brian

[zinman]

brandtb1919, I have the same setup for my 2020 Solitude 372WB and have had no problems touching my bed rails. I do have a hard trifold tonneau cover and the Morryde capture plate comes within two inches when hitched but has not presented a problem. Still no issues when turning. Safe travels.

[brandtb1919]

Thank you for the input zinman! I am actually glad to hear your setup works with a tri-fold tonneau. Sounds like there is a chance I may not have to abandon mine.

Brian

[Alfredo]

I pretty well have the same question. I have 2021 F250 short box coming and just purchased a 150 series 295rl. I am also going to get the 20k Pullrite superglide. Before I buy a tonneau cover I want to make sure the pin box is going to clear the rolled up or folded up portion near the back window when I make a tight turn or will the superglide move back far enough towards the tailgate that the folded tonneau cover doesn't even come into play. I am considering purchasing another Bakflip MX4. I estimate the folded up portion is about 4" over the bed rail. Anybody have experience with this? thanks