User Tag List

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4
  1. #1
    Setting Up Camp
    Join Date
    Mar 2015
    Location
    Armstrong, BC, Canada
    Posts
    19
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Dining room slide.

    We have a 29RL Reflection. At the bottom of the slide it is not coming in all the way. It sticks out about 2 to 3 inches. The top of the slide comes in like they should. During the PDI at the dealer they said that was normal.
    just doesn't look right. It sticks out so far I'm worried about the wind catching it and tearing off the moulding.
    Any ideas on how to fix this?
    Attached Thumbnails Attached Thumbnails 20150322_161654.jpg  

  2. #2
    Fireside Member
    Join Date
    Nov 2014
    Location
    Ellicott City, MD
    Posts
    48
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    I'd have the same concern about the wind catching it. I have a 303RLS and the slide is ahead of the wheel openings where the wall is straight so I don't have the same issue. Looks like the slide gasket is evenly compressed though so it can't close the gap any more than it is.

    It also seems like a lot of sealant on the front section of the wheel opening molding. I would think that would've lined up with the straight wall much better than it appears.
    Kevin & Ginger
    2015 Reflection 303RLS #1816
    2018 Chevrolet Silverado / 3500HD DRW CC / Duramax
    Anderson Ultimate 5th Wheel Connection

  3. #3
    Site Sponsor Dave and Monica's Avatar
    Join Date
    Nov 2013
    Location
    Gore Bay, Ontario
    Posts
    2,171
    Blog Entries
    6
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Welcome to the forum and congrats on your new camper.

    Adjusting the dining room slide so that it's fully retracted top and bottom, side to side are easy adjustments for the dealer to do. The picture you posted shows that it's out too far at the bottom. Unfortunately you should have insisted for it to be corrected before you signed off on the PDI. I had them working on the kitchen slide for the same thing before I accepted our camper. You may as well wait until you've camped in it a couple times in case there's more things requiring attention.

    Dave
    Dave and Monica - Gore Bay, Ontario
    Vitus the Hungarian Vizsla
    2014 Reflection 337 RLS #129
    2008 F250 V10 CC Lariat RWD

  4. #4
    Setting Up Camp
    Join Date
    Mar 2015
    Location
    Armstrong, BC, Canada
    Posts
    19
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Thanks. We do have a couple of other small things to get taken care of. Will get them to do it then.

Similar Threads

  1. Can i move the Dining room table?
    By edmondpagan in forum General Tech Topics
    Replies: 3
    Last Post: 11-03-2016, 08:23 PM
  2. 357BHS slide out manual override location on bunk room slide
    By Navymustang in forum General Discussion
    Replies: 2
    Last Post: 05-29-2016, 10:03 PM
  3. Dining room slide doesn't close all the way
    By hlozano in forum Exterior
    Replies: 4
    Last Post: 05-05-2015, 12:18 PM
  4. 2015 323BHS Dining Room Slide
    By droidguru in forum General Discussion
    Replies: 24
    Last Post: 10-27-2014, 08:12 PM
  5. Squeaky floor in dining room slide
    By Weldersweetheart13 in forum General Tech Topics
    Replies: 2
    Last Post: 10-22-2014, 06:37 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

DISCLAIMER:This website is not affiliated with or endorsed by Grand Design RV, LLC or any of its affiliates. This is an independent site.