Anybody,

I am a new owner of a Reflection 150 260rd. Was playing around with my new RV with manual in hand, and was on the page of leveling. When I was using the auto-levling feature and that the leveling system did lift one of the RV's tires off the ground, which according to the manual is a major no no !!!! Reverted everything back to the hitch mode, and started over. Mind you, the RV was sitting on a semi-level piece of cement (driveway). Tried the self-leveling system again and noticed the same thing happening. I did read that the RV HAD to be level before the movement of the slide-out. Below are the current steps am I doing to setup my new RV.

1. Park the RV.
2. unhitch the camper from the truck.
3. put blocks under leveling jacks.
4. Connect power from RV to house or campsite power.
5. Start the self leveling system ( level RV )
6. With camper level, proceed to move slide-out into position.
7. Open up camper, put awning out and etc.
8. Enjoy new RV

With the above being said, is there something I am missing in my leveling process or is there more to leveling that I should do? Should I being doing the leveling manually first, or leveling front to back or side to side first then using the auto-leveling system? The manual itself did NOT say either way. Any help in this would be greatly appreciated.