Ideas on how to set up docking station

[trailboss]

Hi I am new to this just bought a 2021 297 RSTS and looking at ways to set up the docking station with a filter and a regulator please post pictures and your ideas and thoughts thank you

[trailboss]

Pictures and ideas like this

[FT4NOW]

Ha, I recognize that picture, that's from my Momentum before I ripped out the Nautilus panel and redid the plumbing. I used that regulator daily for 3 years when we lived in our Momentum, never had any issues. You get what you pay for when it comes to regulators.

Here is the after picture from the rebuild.

Sent from my SM-G950U using Tapatalk
Attachment 32417

[trailboss]

Ha, I recognize that picture, that's from my Momentum before I ripped out the Nautilus panel and redid the plumbing. I used that regulator daily for 3 years when we lived in our Momentum, never had any issues. You get what you pay for when it comes to regulators.

Here is the after picture from the rebuild.

Sent from my SM-G950U using Tapatalk
Attachment 32417

Looks good

[boyscout]

Ha, I recognize that picture, that's from my Momentum before I ripped out the Nautilus panel and redid the plumbing. I used that regulator daily for 3 years when we lived in our Momentum, never had any issues. You get what you pay for when it comes to regulators.

Here is the after picture from the rebuild.

Sent from my SM-G950U using Tapatalk
Attachment 32417

That attachment gives me the following error:

Invalid Attachment specified. If you followed a valid link, please notify the administrator

What regulator did you use in the original setup? Thx.

[boyscout]

Pictures and ideas like this

I'd add quick-connect fittings to that, at least one at the bottom where the park water supply connects.

I don't have a picture of mine, but if I did I wouldn't post it because it pales in comparison to @FT4NOW's.

However by employing a couple of brass elbows, a couple of 3' lengths of that excellent Flexzilla hose you seen in the photo, a bunch of quick-connects, and a regulator and pressure dial assembly with quick-connects, I've significantly reduced the time and fiddling involved in setting and breaking camp.

[315RLTSinPA]

Here you go.

[FT4NOW]

That attachment gives me the following error:

Invalid Attachment specified. If you followed a valid link, please notify the administrator

What regulator did you use in the original setup? Thx.

I'll try this again, hope it shows up. The regulator is made by Zurn Wilkins if I recall. I could only find it in 3/4" pipe which is why I used the reducers. I do have quick connect fittings now. I kept the regulator setup when I sold my Momentum, I havent installed it in the Reflection yet.

Sent from my SM-G950U using Tapatalk

[traveldawg]

This is mine. I get a lot of flack about plumbing both the fresh water and rinse water outlets on the same manifold tho. It's an individual choice as to how you plumb the whole thing.

[Richter]

Not sure exactly what you’re looking for, but here’s what I did. We put the pressure regulator on first, then the water hose. It doesn’t protect the water hose from high pressure, but I’d rather replace a $10 hose than a $50 regulator because someone saw it on the pedestal and decided that they wanted it more than I do...