Installing Lippert 3.0 rear stabilizers

**J Maguire** · 03-12-2021, 10:15 PM

Our GD came with the wrong stabilizers; they're too long, they're sending out shorter ones. They appear to be plug and play. Is this accurate? Anyone have any first hand knowledge here? Thxs

**huntr70** · 03-13-2021, 06:56 AM

I believe all of Lippert electric stabilizers have the same plug ends.

**[email protected]** · 03-13-2021, 07:37 AM

Those look like they are even longer than the ones on our Solitude S Class.

**J Maguire** · 03-13-2021, 08:21 AM

Originally Posted by huntr70

I believe all of Lippert electric stabilizers have the same plug ends.

Connections would be the same but what I'm assuming is the on board computer would accept the new ones and move right along with out any downloads or updates?

**J Maguire** · 03-13-2021, 08:22 AM

Originally Posted by [email protected]

Those look like they are even longer than the ones on our Solitude S Class.

Wondering if they were out of stock on the correct length so stuck these on to move it out...

**[email protected]** · 03-13-2021, 08:48 AM

Originally Posted by J Maguire

Connections would be the same but what I'm assuming is the on board computer would accept the new ones and move right along with out any downloads or updates?

Good bet. I would assume the shorter ones would work ok with the controller, but you know what they say about assumptions, a call to LCI would verify.