2017 Reflection 318 RST. Bedroom slide not functioning. Wires running from the rocker switch to the (new $$$) Schwintek controller have continuity. The controller and slide motors work in and out if 12v jump is applied to the extend and retract pins. All other slides and components work fine. The leads in/off the switch are all firmly attached. The next move tomorrow is to attempt to decipher the wiring jumble behind panel and look for a possible loose connection. Last time (last year) when extending the slide did stutter a bit and then wouldn't retract which could indicate a bad connection in wiring or a bad switch but I'm open to suggestions. Merci.