Good afternoon all! I just got my first reflection less than a month ago, today when i tried to raise the rear stabilizer jacks they did not want to go up, the front ones work just fine. I did hear the motor trying to turn but and then it just quit. After a while i come back and check to see if the auto reset breaker did it's job by resetting but it does the same thing. I did check to see if there was power at the switch and there is...I was trying to see about the ground wire but the switch that i have only has 3 wires on the back, the black one is capped off. I have tried to do my homework by looking at the Lippert psx1 manual and reading other solutions online but i haven't been able to get it to work. I just order another reset breaker and see if that helps but i was wondering if anyone had any ideas that i should try, i could just take it back to the dealership but that's an hour away and I'm full timing. Either way i have a month before i have to move again and worst case scenario i can manually lift them but i would like to get it working since this is a brand new 2021 reflection travel trailer. Sorry, if this is in the wrong forum...Thanks again to anyone that reads this post.