User Tag List
Thanks: 0
Results 11 to 20 of 35
Thread: Dimmer Switch in Reflection
-
04-27-2021, 02:41 PM #11
- Join Date
- Mar 2021
- Location
- Fairfax, VA
- Posts
- 23
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
-
06-05-2021, 04:37 PM #12
-
06-24-2021, 03:08 PM #13
- Join Date
- Jun 2021
- Location
- Bradenton, FL
- Posts
- 1
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
So can you place this on the output side of the switch on the panel? I just ordered on but was thinking of trying it that way for the awning and ceiling lights.
2017 Grand Design 2800BH
2014 Ram 2500 4x4
-
06-24-2021, 06:58 PM #14
On the 2017 you might want to use the other dimmer switch many here have spoken about. Not sure how this switch on your rig.
-
07-11-2021, 12:32 PM #15
-
08-20-2021, 05:36 PM #16
-
08-20-2021, 05:58 PM #17
-
08-21-2021, 05:57 AM #18
- Join Date
- Mar 2018
- Location
- Southeast Ohio
- Posts
- 60
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Here you go. On my trailer the One Connect board is located behind panel in curb side pass thru, first picture. Second picture is what it looks like. Third is a over view of the wires needed. The fourth and fifth is the grounds, the two with one small gray is the outlet ground. The three white with one gray is the inlet from the one connect. The yellow and gray is power from the one connect. The two brown with white stripe is the outlet to the awnings. It is hard to see the white stripe in the picture, there is a gray wire with the browns is the outlet to the awnings. On a side note this is where you could separate the awning lights if you wanted.
2018 imagine 2970 RL pull with a 2012 Chevy Duramax 3500 srw[SIGPIC][/SIGPIC] And now a Reflection 315 RLTS
-
08-21-2021, 05:59 AM #19
- Join Date
- Mar 2018
- Location
- Southeast Ohio
- Posts
- 60
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Had to break pictures up here are the last two. Sorry they are not in order,
2018 imagine 2970 RL pull with a 2012 Chevy Duramax 3500 srw[SIGPIC][/SIGPIC] And now a Reflection 315 RLTS
-
08-21-2021, 07:57 AM #20
Re-pack bearings necessary?
Today, 09:25 AM in Axles, Brakes, and Suspension