Lippert Tire Linc setup, as in, changed from original setup.

**4x4dually** · 05-11-2022, 12:55 PM

I currently have the One Control app and it has my TPMS sensors setup as RF, RR, LF, and LR as you would expect from a tandem trailer. What I want to do is add sensors to my on-board air system as well as my spare (if it will linc far enough to reach the spare).

How does one change what is shown in the app? The app has currently been updated from the blue background to the new white version (not sure when it updated, but I sure didn't tell it to).

Has anyone changed the setup before? I'm wondering if I don't configure it to a tripple axle view and just put the other two as the extra tires? You'd think the app would have "aux" channels or "spare" channels but I'm just not too familiar with it.

Any ideas how to make changes? I've google and search this forum without finding what I'm looking for.

**4x4dually** · 05-12-2022, 01:28 PM

No one has changed from four tires to six or vice versa on the app before? Bueller? Bueller?

**4x4dually** · 05-16-2022, 09:40 AM

No one has changed their setup? I guess I'm gonna call Lippert at some point when I get time to do it. I can't find anything on the internet about it.

**A.Texas.Yankee** · 05-16-2022, 04:18 PM

Originally Posted by 4x4dually

No one has changed their setup? I guess I'm gonna call Lippert at some point when I get time to do it. I can't find anything on the internet about it.

You have to reset the tire Inc and set it up all over again from scratch start to finish. When you do, you must select "custom" for vehicle type. That will allow you to customize layout but only in single tire vs dually type thing. For example on mine I customized to be:

[] [] <-- front truck tires
[][] [][] <-- rear truck tires
[] [] <-- front trailer axle
[] [] <--middle trailer axle
[] [] <--rear trailer axle
[] [] <-- truck spare (l) / trailer spare (r)

Full-time Traveling Family ,'21 Momentum 395MS-R, '21 F450 King, 2000watts solar, Dual Victron MP-II 12/3000 2 x 120v, 1220ah LiFePo4

**4x4dually** · 05-17-2022, 06:05 AM

Cool. Can you give me some insight on how to reset it and start over, that's what I can't seem to find.

**stroguy** · 05-17-2022, 07:23 AM

I believe you will do a reset of the comm module in the basement or belly. Then in the app you would rediscover devices.

https://www.youtube.com/watch?v=Z5cYZDrWX5s&t=621s

**4x4dually** · 05-17-2022, 08:11 AM

Originally Posted by stroguy

I believe you will do a reset of the comm module in the basement or belly. Then in the app you would rediscover devices.

https://www.youtube.com/watch?v=Z5cYZDrWX5s&t=621s

Thanks. Not sure why I didn't find that video.