I added the ''Safety Strut Support Bracts'' to the rear of my 2600RB bumper. I had to drill holes thru the frame to enable the bolting of these brackets. I went above and beyond the instl directions, bought and used thru bolts all the way thru which I felt was better and stronger instl. They fit up nice and according to the manufacturer, they are suppose to add 400 lbs of cargo carrying capacity to the bumber ?? Now with that said, I do not intend to go anywhere close to that capacity. I am going to install a dual hitch steel cargo carrier that weighs approx 60 lbs. I then will carry my 55lb Honda Gen set, two five gallon cans of fuel and small misc stuff that I estimate will not exceed 200lbs at most.

I thought I would post this for others who may be wondering how to stiffen up there bumper,,,