User Tag List
Thanks: 0
Likes: 0
Results 1 to 10 of 10
Hybrid View
-
04-16-2021, 12:32 PM #1
- Join Date
- Dec 2020
- Location
- Austin, TX
- Posts
- 12
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Furrion MPPT 25A Solar Charge Controller issue?
My 2021 Transcend that I picked up in December 2020, included the solar package with 165W Furrion solar panel and this Furrion MPPT 25A charge controller. Also, I had the dealer throw in a 2nd battery (basic Interstate). Trailer was plugged in the first couple of months, but hasn't been for the last month or so, and I've noticed battery readings different than what I would expect when I casually check with my handheld DMM. I recently installed a basic battery monitor and am more closely checking the behavior. (Unfortunately, the battery monitor doesn't keep a history, so I'm having to spot check. Nor does it indicate current direction - charge vs. draw). Here is what I've seen so far.
Several weeks ago - observation that made me pay more attention (before battery monitor installed)
Battery reading = 12.6V
-I don't recall if battery disconnect was in on or off position, but even if "on" (i.e. connected), everything that could be turned off was...including fridge. So current draw should have been very low. Weather had been decent, so I would surely have expected solar to keep batteries fully charged. In fact I would have expected to read the float charge level specified in the manual (13.2V). This reading was during the day on a sunny day. Charge controller is set to correct type of battery, and main LED was blinking green indicating it was charging (per the manual). In poking around, I physically disconnected the battery terminals and looked them over. When I physically reconnected the battery, I then measured 14.3V, which is what the manual shows as the "bulk" voltage level. So, it would appear like physically disconnecting and reconnecting the battery reset something in the controller, and then it started charging. That doesn't seem right.
Yesterday - with battery monitor installed
Battery reading = 13.2V (float level), fluctuate between 0mA - 100mA (I'm assuming that is how charge controller maintains float level)
Checked around noon, partly cloudy
Battery disconnect switch set to "off" (i.e. disconnected), so there shouldn't be much if any current draw
Today
Battery reading = 12.9V, 0mA
Checked at noon, overcast sky.
Battery disconnect switch set to "off" (i.e. disconnected), so there shouldn't be much if any current draw
Main LED blinking green on charge controller, indicating it thinks it's charging as normal
It would seem to me the charge controller got back into the non-charging state for some reason. I would expect it to still be generating a little bit of power even with overcast skies.
I set the battery disconnect switch to "on" (i.e. connected), so see if that draws the battery down. As expected, current reading jumped to ~115mA. Thinking maybe charger won't re-engage until battery drops to a certain level. But I don't think that would be desired behavior.
I'll check again later and post my observations.
-
04-16-2021, 03:36 PM #2
- Join Date
- Mar 2019
- Location
- Ontario, Canada
- Posts
- 71
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Following....
Sent from my LM-G900 using Tapatalk2021 Transcend 261bh
2021 Ford F-150 3.5eb
-
04-16-2021, 05:14 PM #3
- Join Date
- Mar 2020
- Location
- ON & QC Canada
- Posts
- 4,768
- Mentioned
- 38 Post(s)
- Tagged
- 0 Thread(s)
FWIW for your investigation, even with the battery disconnect on, there's some what we have come to call parrisitic draw from things like the CO2 sensor that are always on. It's not much though.
Steph & Lise
2019 F150 Lariat 2.7 EB
2020 Imagine XLS 22MLE
-
04-17-2021, 01:31 PM #4
- Join Date
- Dec 2020
- Location
- Austin, TX
- Posts
- 12
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I periodically checked on the battery yesterday and today. Pretty consistent behavior with battery disconnect set to "on" (i.e. connected), there was about 120mA draw, and with the battery disconnect set to "off" (i.e. disconnected) there was no current flowing through the shunt. As a result, the battery voltage slowly dropped to 12.6V since I left the battery connected. Yesterday was overcast all day but today had the sun poking through the clouds on and off. Today, during a bright sunny moment around 2pm so solar panel was in full sun, I checked and saw similar behavior. Shunt measured ~120mA with battery connected and 0mA with battery disconnected via the switch. All the while, green LED is blinking happily on the controller. So, with battery disconnected via the switch, I physically disconnected the negative terminal for a moment and reconnected. As I had observed the other day, voltage immediately jumped to 14.2V and with 2-3A going through shunt. That tells me the controller somehow gets into a state where it thinks it's charging, but it really isn't. And physically disconnecting the battery for a moment resets something in the controller so it starts functioning again upon reconnecting. Time to contact Furrion.
-
04-17-2021, 01:33 PM #5
- Join Date
- Dec 2020
- Location
- Austin, TX
- Posts
- 12
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
-
08-01-2021, 10:06 PM #6
- Join Date
- Jul 2020
- Location
- Wetaskiwin, AB Canada
- Posts
- 135
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
I'm hoping someone can help me figure something out.
After picking up my trailer from the shop for a recall, i went boondocking Friday (son's wedding) and my MPPT 25A solar charge controller LED's we're working just fine.
I discovered today that my batter had been disconnected the whole weekend (obviously something from the shop). Anyhow, now my controller is only showing a yellow light on the sealed battery mode connector...the green light for the charge fault indicator won't even light up (it did earlier today). On top of this, my fridge doesn't work, even the light won't turn on. And it won't even work with shore power on. Is this connected, or do I have to separate and frustrating issues? I sure and the hell hope the fridge issue is NOT the fuse! I've already heard about how you have to fix that damn thing. Any body?
-
08-02-2021, 06:23 AM #7
- Join Date
- Mar 2020
- Location
- ON & QC Canada
- Posts
- 4,768
- Mentioned
- 38 Post(s)
- Tagged
- 0 Thread(s)
You should start a new thread, this one is a bit old and maybe not related to your issue. Is your battery disconnect off (meaning you can't remove the key)? How low is your battery? Have you check the water level in your battery assuming it's a LA? Last time the dealer had ours for 2 weeks, they left the battery on and killed it. It could be that the cheap battery they give us is damaged. You can get the battery tested.
Sent from my SM-P610 using TapatalkSteph & Lise
2019 F150 Lariat 2.7 EB
2020 Imagine XLS 22MLE
-
01-13-2022, 08:05 AM #8
- Join Date
- Jan 2022
- Posts
- 2
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I seem to have this same problem. Did you ever find a solution?
Broken leafspring. Another….
Today, 05:26 AM in Axles, Brakes, and Suspension