User Tag List
Likes: 0
Results 1 to 4 of 4
-
04-18-2021, 06:35 PM #1
- Join Date
- Feb 2021
- Posts
- 31
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
On gas hot water heater cycle a lot
When hot water heater is on gas it cycles a lot
Gas burner runs about 10 to 20 minutes to heat up water then off then the burner fires up about ever 3 to 5 minutes after that I’m thinking to keep water at a temp
But I was needing to know if there is a way to make it have a bigger window for starting and stopping????
2021 297rsts
-
04-18-2021, 08:04 PM #2
-
04-18-2021, 08:23 PM #3
- Join Date
- Feb 2021
- Posts
- 31
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Yes I could do that
-
04-18-2021, 08:59 PM #4
If you want to just turn it on and let it do it’s thing, you should check basic stuff first.
1. Verify all connections are solid and good
2. Jiggle the wires a bit and see if it changes the behavior.
3. Check for bad ground
4. Check all voltages and ohm readings
5. Check airflow
This is all stuff you can do without replacing parts
Not too many things would cause short cycling like that
Thermostat
Gas tube
Airflow
Spark
Gas valve
Circuit Board
Good Luck
Sent from my iPhone using Tapatalk2019 GMC 3500 SRW Sierra Denali Duramax
2020 Reflection 315RLTS
Breakaway Switch Question
Today, 04:10 AM in Axles, Brakes, and Suspension