Wheel lug torque for 310 GK?

[JM0397]

I’ve looked high and low, don’t see anything but a torque order diagram on my pin box, but it’s for the wrong lugnut configuration!
I have: ‘21 310 GK, factory setup, 8-lug Lionsheads wheels.
What’s the torque recommendation?
I think 100-120?

Thanks!

[geotex1]

There's an entire section in your owner's manual. Need to identify your lug stud diameter. If you just have standard 7K axles the studs are 1/2-inch.

[JM0397]

I’ll check The manual again, but it was vague and not helpful on first pass - thanks!

[orbsah]

There’s a sticker on the pin box of my unit that shows lug torque. I’m not sure if GD or the dealer put that on there. Most of the ink wore off but it does say 120. I agree the manual doesn’t make it real clear.

[BobLandry]

120lbs is standard for 1/2" lugs

[JM0397]

Thanks all, I think they put a wrong 5-lug sticker on my pin box.
��

[Chewwi]

Dexter’s manual says no greater than 120 ft lbs. I torque to 110 ft lbs.


2020 2600RB,
2017 Silverado Crew Cab 1500, 6.2L

[AZMike]

I’ve looked high and low, don’t see anything but a torque order diagram on my pin box, but it’s for the wrong lugnut configuration!
I have: ‘21 310 GK, factory setup, 8-lug Lionsheads wheels.
What’s the torque recommendation?
I think 100-120?

Thanks!

Straight out of the Owner's manual.

[JM0397]

Straight out of the Owner's manual.

Right, but with the rig parked in storage, I wasn’t sure the configuration other than 8 lugs and I think we have the 17.5” rims, so no guessing after all, if that’s the case.
I have some rig work to do tomorrow, so I’ll check and report back for clarity.

[DECelt]

My little sticker for 17.5-inch rims with H-rated tires indicated torqued to 130 lbs.