Slide outs stuck - cannot depart

[JCR GD]

Also, keep in mind weak batteries will have lower voltage which results in higher amp draw and tripping the breaker.

[FT4NOW]

Might want to check the fluid level in the reservoir to rule that out as the problem. Need to be hooked to the truck to properly check level, all hydraulic slides and jacks need to be retracted.

Sent from my SM-G950U using Tapatalk

[sedonami]

The challenge we have is that we aren't anywhere near home and won't be for the next 4 1/2 months. Getting the slides in got us to our next location which we'll be at for the next 4 days. I'm hoping I can either diagnose the issue here, bring in a mobile tech or use this technique long enough to get us to a dealer if necessary.

All these suggestions are fantastic and I'll start looking into each of them. Thank you!

[sedonami]

I'm not sure if this is related, but we're also noticing a cracking or popping noise coming from some of the leveling jacks at times.

[sedonami]

Here is a picture of our reservoir before we set up last night. To me it looks a little low.

[JCR GD]

For the popping...

[JCR GD]

Here is a picture of our reservoir before we set up last night. To me it looks a little low.

Is that with all jacks up and slides in?

[Second Chance]

I'm not sure if this is related, but we're also noticing a cracking or popping noise coming from some of the leveling jacks at times.

Not related - but common. See the flyer @JCR GD posted above.

Rob

[Second Chance]

Here is a picture of our reservoir before we set up last night. To me it looks a little low.

If you look closely, there are lines for "Full" and "Low." It looks like the fluid level is right where it should be when everything is retracted. There's a section in your manual about this.

Rob

[xrated]

If you look closely, there are lines for "Full" and "Low." It looks like the fluid level is right where it should be when everything is retracted. There's a section in your manual about this.

Rob

Rob....you're 100% correct on the lines being there...but, they are hard to see. I took a Black magic marker and added a black line at the full mark to make it easier to see. And yes, his tank looks full.