User Tag List

Results 1 to 10 of 16
Thread: Hot water heater issues
-
05-05-2021, 08:55 AM #1
- Join Date
- Dec 2020
- Location
- Fort Myers
- Posts
- 65
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Hot water heater issues
Hello, I have a 2021 2600rb which had a thermo fuse blown. I direct wired it and the gas worked fine. Ordered new thermo fuses and when I replaced it, it would lite but not stay on. It would try 3 times lite then go off, then the dsi fault would go on. Any ideas? Thxs
-
05-05-2021, 09:13 AM #2
- Join Date
- Jul 2017
- Location
- SW Indiana
- Posts
- 1,742
- Mentioned
- 36 Post(s)
- Tagged
- 0 Thread(s)
Low propane, propane tank excess flow valve tripped, propane lines need bleeding, flame sensor out of position or bad, flame out of adjustment or dirty orifice are a few ideas to check.
John & Kathy
2014 F250 Lariat FX4 6.2L SBCC
2014 Reflection 303RLS
SW Indiana
-
05-05-2021, 09:22 AM #3
- Join Date
- Dec 2020
- Location
- Fort Myers
- Posts
- 65
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
When I by pass the thermo fuse it works, so any propane feed issues or dirty orafice would not be the case.
-
05-05-2021, 09:59 AM #4
- Join Date
- Sep 2019
- Location
- Myrtle Beach SC
- Posts
- 26
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I'm new to rvs but I am a plumber never tore into water htr yet but your last statement correct but I believe if its on electric that means it would work off of element instead of burner bad element maybe I just haven't worked on my rv water heater yet just a thought hope it helps
Sent from my SM-G960U using Tapatalk
-
05-05-2021, 10:01 AM #5
- Join Date
- Dec 2020
- Location
- Fort Myers
- Posts
- 65
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Yes Wayne, it does work when on electrical. Cycles on off 3 times on gas then defaults. Thxs
-
05-05-2021, 10:05 AM #6
- Join Date
- Sep 2019
- Location
- Myrtle Beach SC
- Posts
- 26
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
So its the gas side your having problems with if its doing that there should be a flame sensor clean it with steel wool and try again
Sent from my SM-G960U using Tapatalk
-
05-05-2021, 10:07 AM #7
- Join Date
- Sep 2019
- Location
- Myrtle Beach SC
- Posts
- 26
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
After it lights if gas valve does not detect flame and it will try afew times gas valve thinks no flame and shuts down
Sent from my SM-G960U using Tapatalk
-
05-05-2021, 10:13 AM #8
- Join Date
- Sep 2019
- Location
- Myrtle Beach SC
- Posts
- 26
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Even if it lits gas valve thinks it didnt
Sent from my SM-G960U using Tapatalk
-
05-05-2021, 10:18 AM #9
- Join Date
- Dec 2020
- Location
- Fort Myers
- Posts
- 65
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Then why when I bypass the thermo fuse it stays lit? With fuse in it won’t stay lit?
-
05-05-2021, 10:20 AM #10
- Join Date
- Dec 2020
- Location
- Fort Myers
- Posts
- 65
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I will try cleaning up but this is a brand new TT HW heater only has a few hours on it. Maybe a defective thermo fuse. I bought two of them, I’ll try the other also. Thxs
Furrion refrigerator
Yesterday, 11:53 PM in Appliances