351-M All 3 MaxxAir Vents are not working.

[Yabos2]

Hello Everyone,

I have a 2021 351-M with all 3 MaxxAir Vents with rain sensors are not working.

The 351-M has a MaxxAir vent in the kitchen area above the stove,
one in each of the 2 bathrooms.

I have checked all the GFCI's to make sure nothing was tripped.
I also checked the circuit breakers in the cabinet to make sure that none of them are tripped.

Is there any other location that could be tripped that would cause all 3 MaxxAir fans to completely stop working?

Thanks for any and all help.

Yabos2

[FT4NOW]

Welcome to the forum. They are all 12v DC, the things you checked are 120v AC. Do your lights and other 12v items work? Have you checked fuses?

Sent from my SM-G950U using Tapatalk

[cfoster]

Hello Everyone,

I have a 2021 351-M with all 3 MaxxAir Vents with rain sensors are not working.

The 351-M has a MaxxAir vent in the kitchen area above the stove,
one in each of the 2 bathrooms.

I have checked all the GFCI's to make sure nothing was tripped.
I also checked the circuit breakers in the cabinet to make sure that none of them are tripped.

Is there any other location that could be tripped that would cause all 3 MaxxAir fans to completely stop working?

Thanks for any and all help.

Yabos2

Hello,

I have a 351 and 354. The MaxxAir Fans run on 12 volts and are not connected to breakers or GFCI's. Check the fuses under the breakers as well as the battery fuse near the battery. Also make sure your battery disconnect is on. Hope this helps. Since all 3 do not operate I would suspect that one of these is the culprit.

[Yabos2]

Hello,

I have a 351 and 354. The MaxxAir Fans run on 12 volts and are not connected to breakers or GFCI's. Check the fuses under the breakers as well as the battery fuse near the battery. Also make sure your battery disconnect is on. Hope this helps. Since all 3 do not operate I would suspect that one of these is the culprit.

Thanks for everyone's help.

It was a fuse under the breakers that tripped. Replaced the fuse and all are working again.

Thanks again.