reflection fwd landing pad

**melbin** · 05-12-2015, 01:41 PM

went out to hook up for pretrip and fwd landing pads would not work, switch kinda spongy no blown fuse, any ideas? thanks

**Lingerlonger** · 05-12-2015, 04:16 PM

If it is not a blown fuse, it is probably a broken switch.

You can use the manual crank. The access point (on my 337RLS at least) is on the street side, behind the propane bottle.
There might be a plastic plug covering the access hole, about 1 inch diameter.

If you have the same kind of switch to control the rear stabilizers, you could try exchanging them.

Good luck.

K

**Cate&Rob** · 05-12-2015, 05:55 PM

Hi melbin,

These switches are not the most "robust". Sounds like you have a broken switch. These are not difficult to replace. Contact GD directly by phone and they will likely send you one by priority mail. See this prior post for more details.
http://www.mygrandrv.com/for...bilizer+switch

Rob

Steve and Lynne · 05-12-2015, 06:40 PM

Broke switch a few months ago, service/parts sent us two switches. A little different than OE, but straightforward to install. Agree they are not "robust", but we still have one spare!

**pauliwalnutz** · 05-13-2015, 07:29 AM

Did you check the fuse that is near the battery?

**melbin** · 05-13-2015, 08:16 AM

i did paul, but that was not the culprit, had power to switch but switch was not functioning like it was suppose too. I found toggle portion of switch broken, switch is apparently fragile on toggle side, thank you for your input. have a good one