User Tag List
Results 21 to 30 of 32
-
01-16-2022, 01:28 PM #21
- Join Date
- Sep 2020
- Location
- Thunder Bay, Ontario, Canada
- Posts
- 1,930
- Mentioned
- 21 Post(s)
- Tagged
- 0 Thread(s)
The furnace will be close to not working at 10k feet because of thinner air. The air inlet to the burner needs to be restricted a bit at altitude. Probably why your RV tech had no issue having it run properly at a lower elevation with the same tanks.
2018 Dodge 3500 6.7 Cummins SRW w/Aisin
2021 Reflection 303RLS
New to RV'ing since 1997
-
01-16-2022, 06:04 PM #22
- Join Date
- Dec 2021
- Location
- Sicamous, BC
- Posts
- 117
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
-
01-16-2022, 06:41 PM #23
- Join Date
- Sep 2020
- Location
- Thunder Bay, Ontario, Canada
- Posts
- 1,930
- Mentioned
- 21 Post(s)
- Tagged
- 0 Thread(s)
Well, that would be the way to go for sure if you were staying at altitude. But you would be kind of pooched almost everywhere else in the country where you are down closer to sea level.
My previous trailer, a 2006 had an adjustable air inlet by the ignitor. It could be adjusted to a nice blue flame. Not sure if the adjustability is there on newer fridges. I have yet to look on our new GD.2018 Dodge 3500 6.7 Cummins SRW w/Aisin
2021 Reflection 303RLS
New to RV'ing since 1997
-
01-16-2022, 08:29 PM #24
- Join Date
- Jul 2017
- Location
- SW Indiana
- Posts
- 1,985
- Mentioned
- 42 Post(s)
- Tagged
- 0 Thread(s)
Doing a little searching and it seems piezo igniters in general experience problems at high altitude and butane lighters with flints are sold for high altitude use. Seems likely it’s oxygen levels. No authoritative sources though.
John & Kathy
2014 F250 Lariat FX4 6.2L SBCC
2014 Reflection 303RLS
SW Indiana
-
01-19-2022, 02:28 PM #25
- Join Date
- Aug 2017
- Location
- Idaho Springs, CO
- Posts
- 8
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Furnace Failure At High Altitude
I have been dealing with this for years and have found no solution. I live at 7,800 feet elevation and the furnace will not light. Take it to the dealer in Denver at 5,280 feet elevation and it works perfectly. We have traveled over 30K miles and anytime you get too about 7,000 feet elevation, the furnace failed. I have taken it to three (3) dealer, dealers and all say there is nothing they can do about it.
As you know, at higher elevation it is colder and that is where you really need the furnace to work. Hope you find an answer and if you do, please let me know. I have a 2017 Image, 3200RB.
-
01-19-2022, 03:07 PM #26
- Join Date
- Nov 2020
- Location
- British Columbia, Canada
- Posts
- 15
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I have had many problems with the furnace not lighting but not at altitude. Temperature and pressure in the tank are related and at high altitude I believe the pressure in the tank would also decrease. My experiences all comes from camping in severe winter temperatures in Whistler. With smaller tanks and particularly when they get low on gas they will freeze up and not have enough pressure to run the furnace. When gas is being used the venturi effect also cools the tank by quite a bit thereby decreasing inside pressure. Typically in Whistler most folks go with 100 lb tanks as the surface area to volume ratio is less, so easier to keep up pressure. Never had the lighting problem since using large volume tanks. With 30 lb tanks which are getting low on gas I’ve had the furnace quit near freezing temperature. Heating the tank should solve the problem. Testing with a full warm tank should confirm the problem.
Always bad news when your furnace doesn’t light in winter. Good luck.
-
01-19-2022, 10:46 PM #27
- Join Date
- Jul 2020
- Location
- California
- Posts
- 8
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Try an electric blanket on the tanks! Or use heat trace tape if you have electric hook ups. Propane loses its pressure the colder it gets outside.
-
01-21-2022, 01:53 PM #28
- Join Date
- Jan 2022
- Posts
- 15
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Sorry, just saw your post. So far I have had success with filling my propane tanks at my local propane fill station. My plumber/hvac tech says he has a similar issue with his RV at altitude/cold weather. When the tanks are full my furnace will fire on the first or second click. Once the tanks are down to about 2/3-1/2 a tank it takes a few more tries but will eventually light. It also seems to have more to do with temperature than altitude. So far my solution has been to keep the tanks full (I keep three 30lb tanks) and swap in the third tank once the other two are at about half or a little lower. I'm still experimenting with it and may buy an electric propane tank heater.
-
02-12-2022, 09:37 PM #29
- Join Date
- Jan 2022
- Posts
- 15
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Update. Bought a manometer. Set the propane regulator to around 12 in/h20 per the dealers recommendation which came from Dometic. No high altitude kit for this furnace according to Dometic. However, at that setting the furnace has been working like a charm. I also bought two electric propane tank heating pads made by warmguard. I have them covered by an old sleeping bag and protected from the elements with a tarp. I left the bottom open to allow any vented propane to be able to escape. With those propane heating blankets I can actually use the whole bottle of propane. Hope this helps anybody else having similar issues.
-
02-13-2022, 06:22 AM #30
- Join Date
- Sep 2020
- Location
- Thunder Bay, Ontario, Canada
- Posts
- 1,930
- Mentioned
- 21 Post(s)
- Tagged
- 0 Thread(s)
@mountainrv
You set the reg to 12" of water, did it have to be adjusted very much to get that? I don't know what GD would normally set them for. For all I know they may install out of the box without checking.2018 Dodge 3500 6.7 Cummins SRW w/Aisin
2021 Reflection 303RLS
New to RV'ing since 1997
What changed for the new GD...
Today, 02:39 PM in General Discussion