User Tag List
Thanks: 0
Likes: 0
Results 1 to 5 of 5
-
06-15-2022, 09:36 AM #1
- Join Date
- Jun 2022
- Posts
- 3
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Foil wrapped trim pieces bubbling
Within 4 months of getting our 2020 28 BHS trim pieces all around our unit started bubbling. The repair solution from grand design is to cut the foil wrapped trim and replace the sections with new tape/foil. Has anyone been successful in injecting glue into the bubbled areas with a syringe to tack them down? At first it was just the trim inside the cabinets bow its around our door frames too.
-
06-15-2022, 09:53 AM #2
- Join Date
- Aug 2017
- Location
- Florida Space Coast
- Posts
- 3,876
- Blog Entries
- 1
- Mentioned
- 94 Post(s)
- Tagged
- 0 Thread(s)
Gosh. This is a tough one.
I think I'd first press GD to send new trim pieces. I don't think they should peel at all let alone after 4 months.
If all else fails then I would make a small slit in the bubbled ares and inject some glue (not a lot) into the bubbles and press them closed.
It's so hot all over the U.S.; any chance you have it in storage and the temps are really high which might exaggerate the problem?Larry KE4DMG
2022 F-350 KRU SRW LB - Airlift 5000+, ForScan, 37 RDS Aux Tank,
2019 310GK-R - Sailuns; MorRyde IS; Disc Brakes; 20K Reese Goosebox
Search kalakamods for my mods
-
06-15-2022, 10:01 AM #3
- Join Date
- Jun 2022
- Posts
- 3
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Oops sorry hit send
And reqs for glue syringe? Tried a rubber cement one and it didn't work
-
06-15-2022, 10:07 AM #4
- Join Date
- Aug 2017
- Location
- Florida Space Coast
- Posts
- 3,876
- Blog Entries
- 1
- Mentioned
- 94 Post(s)
- Tagged
- 0 Thread(s)
Larry KE4DMG
2022 F-350 KRU SRW LB - Airlift 5000+, ForScan, 37 RDS Aux Tank,
2019 310GK-R - Sailuns; MorRyde IS; Disc Brakes; 20K Reese Goosebox
Search kalakamods for my mods
-
06-15-2022, 10:07 AM #5
- Join Date
- Jun 2022
- Posts
- 3
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Elmer's over superglue?
Anyone Else Getting Tired of all...
Today, 03:27 AM in General Discussion