Reflection 367BHS Kitchen Slide floor

[AJersild]

Hello! This is my first post, hopefully this is the correct place. We purchased a Reflection 367 BHS in July and took it out for 2 weeks. When we got home we noticed the floor of the kitchen slide is separating from the wall on the fridge side. Has anyone had this happen? We have a service appt, but my husband is wondering if he should try to fix it himself. He is a general contractor and does home remodeling. We are worried about what the service dept will do as a "fix". Has anyone had this happen or something similar happen??

[FT4NOW]

Welcome to the forum. If you could post a picture, you might get some good suggestions. Based on the description, without seeing a picture, I would think the slide needs an adjustment (definitely a DIY project if you're handy).

[huntr70]

Not sure I see anything separating.

What I see is the trim flange has a gap. Is there a gap between the actual floor and sidewall? Look on the inside of the refer space and see if there is a gap with the actual wall.

That flat piece is just a piece of trim, not the wall.

You can see the lighter colored wall structure in the gap.

[AJersild]

The floor actually moves on that side. Yes, I know that is the wall, the floor is actually separated from that. I have included a photo of the gap on the inside of the wall by the fridge and there is a crack in the plastic trim piece on the bottom of the slide that you can see when you put the slide out.

[FT4NOW]

That doesnt look right, with that picture, I'd say more than a slide adjustment is necessary. Its possible the slide needs adjustment and the trim put back on.