Black Tank Flusher Inlet Replacement

[Chewwi]

Anyone with hands on experience replacing the black tank flusher inlet connection (pic shown below)? This is the plastic(?) part that your water hose connects to outside the RV that is used to flush the black water tank.

Ours was slightly damaged by some road debris and needs to be replaced. The damage prevents screwing the fitting to the hose. I have the replacement part. The part is threaded and I’m hoping that’s it is not also glued since phyical access to it is going to be very difficult.

Any insight would be greatly appreciated!

[FT4NOW]

I didnt replace mine, but I relocated it when I ripped out my Nautilus system. There is a clip on the back holding it in place and there should be a 1/2" NPT connection on the back. Overall, should be an easy swap.