Bearings and suspension work

[dryfly]

Mr. Frood gives very good advice.

[huntindog]

The week after we picked up new 2022 2970RL, I inspected all and replaced all bearings & seals. I really wanted piece of mind, and got it! I found all (4) wheels had a big "dab" of grease near the inner bearing; pretty much no grease on outer bearings. Yes, this was consistent with each wheel. I put in the CRE3000 and wet bolts then pumped Red-n-Tacky till it oozed out of each outer bearing and each wet bolt. Now I feel better......

in addition, often the new seals are nicked by the ez lube grease hole when installing the drum. it is not much of a problem until you pump grease in using the zerk.
it is best not to use the ez lube feature.