In-Motion Lock

**A.Texas.Yankee** · 09-26-2022, 09:18 PM

Originally Posted by Toy4Rick

Thanks all, I will try that on our next stop

I have a manual switch for the water pump in the wet bay. This switch will also stop the in motion lock as well. Saves having to go inside the camper.

**Scott'n'Wendy** · 09-27-2022, 07:23 AM

Originally Posted by NB Canada

Changing “modes” does not disable the “in motion”lock on my trailer

Wierd...does on mine.

**Scott'n'Wendy** · 09-27-2022, 07:25 AM

Originally Posted by A.Texas.Yankee

I have a manual switch for the water pump in the wet bay. This switch will also stop the in motion lock as well. Saves having to go inside the camper.

This sounds like the winner to me.

**NB Canada** · 09-27-2022, 12:57 PM

Originally Posted by A.Texas.Yankee

I have a manual switch for the water pump in the wet bay. This switch will also stop the in motion lock as well. Saves having to go inside the camper.

Imagines don’t have this

**Yellowdog** · 10-01-2022, 04:12 PM

I get that ALL THE TIME. I press the ok button maybe 6 times and the message goes away. Then turn the unit off. It still does it periodically. A real pain. I have a love hate relationship with it. Plugged into truck or not, still does it.

**Venturer** · 10-02-2022, 06:17 AM

Mine is the same as NB, I or my DW go inside and turn on the main bright blue light switch after unhooking and leveling, then I can control everything from my phone app.

**bhbery** · 10-02-2022, 10:31 AM

I've had the same issues. Then I noticed that the app on my phone had been updated and it had the instruction to operate a physical light switch to disable the in-motion lock. Works every time for me. Make sure you have the latest version of the app.

**Toy4Rick** · 10-03-2022, 08:45 PM

Thanks for the support and the reminder to fully read the pop up on the In-Motion Lock...

Yesterday, disconnected, turn on the interior lights and no in-motion lock message when I went to push the slide out

Good stuff

Rick

**Rabbit** · 10-07-2022, 10:57 AM

I’m still trying to figure out exactly how to keep the app connected and active while driving. Last trip out I did this: without TV connected turned on overhead light from inside coach, pushed connect button, once app on iPhone connected opened the TPMS section of app. App was active at this point. Immediately connected the TV, started TV, switched app to travel mode, opened Sync 3 (F150), started Compass Connect App on Sync 3. TPMS was now active in truck and remained so for entire trip even when phone went to sleep. IMO a much too fussy and complicated process, but it worked. I think…