Fixing a slide that's out of time

[Thesheetster]

I have a 351M that the pantry door popped open and when I opened the slides it hung up that side. Now when the slides are in all the way in both sides look tight like they're supposed to but when they're out I have a gap on the bottom left side. Does anyone know if there is a dyi way of retiming these?

[Hoopy Frood]

What year? How far out did the other side go that wasn't hung up on the door?

[huntr70]

I have a 351M that the pantry door popped open and when I opened the slides it hung up that side. Now when the slides are in all the way in both sides look tight like they're supposed to but when they're out I have a gap on the bottom left side. Does anyone know if there is a dyi way of retiming these?

They have adjustments under the slide out. There isn't any "retiming" or "syncing" like the Schwintek slides.

You may be able to look under the slide and see if something slipped.

[Thesheetster]

It's a 2019. The sofa side went all the way out, and didn't realize what happened until I noticed the fridge side wouldn't go all the way out

[Hoopy Frood]

Yeah, there's no "retiming", as such. Check underneath and see if the plate attached to the rack has been bent, or otherwise is out of adjustment. Have you run it in and out a few times? Also, try pushing the side as it goes out. The same thing happened to ours, and we couldn't see any issues, and after a few trips in and out, and pushing the one side while it was going out, it squared up and now seems to be okay.

[Thesheetster]

The only adjustment I can see is a vertical setting. I can't see anything that is obvious and the rack going into the camper frame is boxed in pretty well and welded. The only way I can see to get in is drop the belly liner and I don't know if that's an easy one man job or not?

[Hoopy Frood]

Seems unlikely, but make sure that plate for the vertical adjustment isn't bent. It's pretty stout, so seems unlikely, but maybe possible.

[Thesheetster]

Yep, I checked that out and both sides are straight and match.

[Hoopy Frood]

How much of a gap are we talking about? At the very bottom? How many times has the slide been used since it happened?

[Thesheetster]

I'll try to push it out the next time I run it.