User Tag List
Thanks: 0
Likes: 0
Results 1 to 2 of 2
-
11-27-2022, 12:25 PM #1
- Join Date
- Nov 2022
- Location
- Manitoba Canada
- Posts
- 46
- Mentioned
- 2 Post(s)
- Tagged
- 0 Thread(s)
Pin size for jack pads Lippert 3.0
I took my rear pads off to paint them before putting on snap pads. I noticed that the hole in the pad and jack is 1/2" but the pin that is supplied it 3/8". Is there a reason to use such a small pin and have the pads all flopping around? Seems to me it will evertually wear the hole bigger like that, but perhaps is so that the pad can confirm to uneven terrain? The front legs are the same with a 1/2" hole. Wondering if anyone has changed these our to 1/2" stainless pins like these here?
https://www.amazon.ca/dp/B095NZZ6H1/...v_ov_lig_dp_it2019 SRW Superduty 6.7 PSD
2021 Grand Design Reflections 31MB
-
11-28-2022, 02:58 PM #2
Freeze Concern
Today, 05:27 PM in General Discussion