Has anyone found a way to do Schwintek Slide Wiring Protection under the trailer?

[powerscol]

I am installing armoring plates above my tires and ran into the Schwintek wiring. Anyone found a way to armor this without undoing the harness?



Thanks for any thoughts.

[Soundsailor]

Not sure what it is called, but there is ducting for cables that is split down the side. You could wrap that around the wires.

[Redapple63]

Here is what you are looking for. Should shield it from most of the bad stuff

https://a.co/d/hQAHSTY

Bill

[Grandesigner]

Not sure what it is called, but there is ducting for cables that is split down the side. You could wrap that around the wires.

Cable tray?

[Soundsailor]

Here is what you are looking for. Should shield it from most of the bad stuff

https://a.co/d/hQAHSTY

Bill

What Bill said.

[powerscol]

Not sure what it is called, but there is ducting for cables that is split down the side. You could wrap that around the wires.

Your talking about wire loom. Not sure it is strong enough. I may be able to adjust the wire to a better protected location.
Thanks for the input.

[Redapple63]

Your talking about wire loom. Not sure it is strong enough. I may be able to adjust the wire to a better protected location.
Thanks for the input.

Yes, this is wire loom. Only other thing the OP can do or disconnect wires at one end and put them through a plastic conduit.

https://a.co/d/cV8D9qB

Bill