Need help on Samsung ice maker.

**LanerC** · 02-08-2024, 02:31 PM

could be the electro-magnetic coil on the fill valve that has gone out. you should be able to hear a click as it goes through the cycling process after you push the cycle buton, even if its not receiving any water from the water line. I dont know if you can even replace it the way things are now.

**el Rojo** · 02-08-2024, 05:03 PM

Good news...I think, LOL.

Well dumb me took 2 days to figure out that this was a upgrade frig. I still have the venting panels on the outside of the slide wall. Well it took about an hour and a half to remove the tight fitting caulked up panel, specially built to keep the weather out, but alas, it's out and I can access the back of the frig. I'm going to have to roll the frig forward a few inches to get the panel off. I'll have to remove trim to do that but I think I'm making progress.

Wish me luck...

**WhittleBurner** · 02-08-2024, 07:11 PM

Originally Posted by el Rojo

Good news...I think, LOL.

Well dumb me took 2 days to figure out that this was a upgrade frig. I still have the venting panels on the outside of the slide wall. Well it took about an hour and a half to remove the tight fitting caulked up panel, specially built to keep the weather out, but alas, it's out and I can access the back of the frig. I'm going to have to roll the frig forward a few inches to get the panel off. I'll have to remove trim to do that but I think I'm making progress.

Wish me luck...

I don't envy you Red, thats going to be a job. It was difficult moving our smaller Atwood out. If you need to go further out a wood box will help keep things balanced.....good luck!

**traveldawg** · 02-08-2024, 09:01 PM

Originally Posted by el Rojo

Good news...I think, LOL.

Well dumb me took 2 days to figure out that this was a upgrade frig. I still have the venting panels on the outside of the slide wall. Well it took about an hour and a half to remove the tight fitting caulked up panel, specially built to keep the weather out, but alas, it's out and I can access the back of the frig. I'm going to have to roll the frig forward a few inches to get the panel off. I'll have to remove trim to do that but I think I'm making progress.

Wish me luck...

Thanks for keeping us up to date.