Hyraulic cylinder ram

[Racerx]

Can anyone verify if these nuts are suppose to be on here like this and not tightened up against the metal bracket. I am not sure if it is suppose to be this way or not.

Sent from my SCH-I545 using Tapatalk

[Racerx]

This is the kitchen slide. Dining rm. Slide is exactly the same.

Sent from my SCH-I545 using Tapatalk

[Specularius]

I believe it depends on the adjustment needed for the slide. The side with the double nuts, sets the push out limit. The Nylock nut sets the pull in limit. These should be adjusted so that the slide seals up when opened or when closed. The main thing is to ensure that the double nuts are tight together, locking them in place.

[Racerx]

I was thinking that was the case, but wanted to verify that. Thank you for the reply.

Sent from my SCH-I545 using Tapatalk

[Dave and Monica]

See page 16 in this LCI manual... http://www.lci1.com/assets/content/s...de-out-web.pdf

Dave

[Racerx]

Thank you for the link. I feel much better knowing it is ok. Thanks for the manual. Downloaded it.

Sent from my SCH-I545 using Tapatalk