User Tag List

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 7 of 7

Thread: slide outs

  1. #1
    Afifth4theroad
    Guest

    slide outs

    We just picked up our 27rl, during the checkout (how to session), we were informed the street side slides must always be operated until the full out or the full closed position and we should never stop the slide and start again. we were advised that doing so creates a high risk of getting the motors out of sync and jamming the slide. I can not find anything about this in the manual. Due to the narrow parking area we would find it useful to be able put the slides only part way out, but of course we do not wish to risk causing damage. Does anyone have any additional information re: this issue?

  2. #2
    King Pin
    Join Date
    Feb 2014
    Posts
    6,521
    Blog Entries
    10
    Mentioned
    41 Post(s)
    Tagged
    1 Thread(s)
    Welcom to the forum. I see this is your first post. We're glad to have you here.

    If your 27RL is equipped with Lippert Schwintek In-Wall slide outs, the information is correct. You should run the room all the way out and then wait a few seconds before releasing the switch. Same on retracting the room. Here is the Lippert manual for the Schwintek slide out system:

    http://www.lci1.com/assets/content/s...-schwintek.pdf

    Jim

  3. #3
    Site Sponsor Dave and Monica's Avatar
    Join Date
    Nov 2013
    Location
    Gore Bay, Ontario
    Posts
    2,171
    Blog Entries
    6
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Welcome to the forum and congrats on your new camper!

    Here's a youtube video from LCI on your Schwintek slide which will answer your questions...https://www.youtube.com/watch?v=hSafAnjxIV4

    BTW, if you have to have the slide only partially open, be aware that it will not be sealed to the elements...only if fully extended or retracted is it sealed.

    Dave
    Dave and Monica - Gore Bay, Ontario
    Vitus the Hungarian Vizsla
    2014 Reflection 337 RLS #129
    2008 F250 V10 CC Lariat RWD

  4. #4
    Long Hauler LCBoyer's Avatar
    Join Date
    Oct 2014
    Location
    Los Fresnos, Texas
    Posts
    4,018
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Congratulations!! Welcome to the group
    2018 Freedom Elite 24FE, 2 Yorkies, and my wife MARILYN, HAM call K0LCB. Traveling around this great country, making friends and seeing lot of beautiful and interesting places

  5. #5
    Afifth4theroad
    Guest
    thanks I used the link to the manual you provided, that covered the proper operation thoroughly. we will be sure to follow the instructions there. and thanks for the welcome.

  6. #6
    Afifth4theroad
    Guest

    thanks

    I found the utube video very helpful as well.

  7. #7
    Site Sponsor JFF&KRN's Avatar
    Join Date
    Oct 2015
    Location
    Peoria, Arizona
    Posts
    578
    Mentioned
    1 Post(s)
    Tagged
    0 Thread(s)
    Interesting stuff! As always I like to learn something new each day. So now i have. The slide in our 303 has this type in the bedroom, but the other two slides only have one motor and it operates the mechanism that brings slide in and out. Like others, when at home we can put street slides out all the way but the door side slide can only go out about 6 inches short of fully extended. Of course this is for loading, unloading, cleaning etc. I have not had any issue with the slides not staying in sync, but then again i haven't done the little slide in bedroom only part way. watching the video(s) on youtube was a great learning deal as well. Thanks for the info!!! Good Luck & Be Safe ! ! !

Similar Threads

  1. Imagine 2600RB Slide-Outs
    By insidescoop in forum General Discussion
    Replies: 9
    Last Post: 11-06-2016, 05:59 PM
  2. Slide-Outs Popping Out
    By anyheading in forum General Discussion
    Replies: 10
    Last Post: 08-03-2016, 09:50 AM
  3. Cleaning the rubber seals on Your slide outs
    By 82alaska in forum General Discussion
    Replies: 2
    Last Post: 07-03-2016, 11:08 PM
  4. slide outs
    By goldsp8 in forum General Discussion
    Replies: 8
    Last Post: 04-15-2015, 11:06 PM
  5. Slide outs moving when raising jacks
    By gtcoleman in forum General Tech Topics
    Replies: 12
    Last Post: 03-11-2015, 11:21 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

DISCLAIMER:This website is not affiliated with or endorsed by Grand Design RV, LLC or any of its affiliates. This is an independent site.